开云体育

http://www.ko4bb.com/Manuals/Tektronix/Tektronix_-_Miscelaneous/Tek_Evaluation_Board.PDF This is the link to the manual. Bob

I know it's nicknamed evil-bay, but anyway, there's a 556 out there right now. It's in Milwaukee, with Type 1A2 and CA plugins.

I have no affiliation with the seller. http://hartford.craigslist.org/ele/3632197113.html -Kurt

Yes, I make a kit, and can send you wires or you could use your own for less. I've been using the same 24 gauge wire as for 7k extenders, but the originals seem to use a little larger gauge. Does

I have a new switch on order but I will try that while waiting. Thanks. And with respect to Tom's advice to just pop the actuator off toward the front with a screwdriver that indeed worked perfectly.

I purchased two TM500 extenders and four 7K extenders from John. I am building the TM500 extenders now. The PWBs are of very good quality and John has done a very good job with supplying the kits. If

Here is another attempt at being an information source instead of a sink :-). The first time I tried to clean a 2235 CRT shield I used a soft lens cloth like you get with a pair of glasses. I thought

Resistors looked more or less OK, that was one of the first things I checked. The 2 2.2M in series had drifted down to 4.2M, while the 1M focus was up to 1.2M, so more or less a wash. More

This probe (it says Fairchild Scientific Instruments 106 on the cable) is a good 1x probe. I bit the bullet and tested it on a scope compensation signal and it has a slight overshoot but a very flat

Thanks Craig, Craig was referring to his spreadsheet with tallies of types of wire used, (but not their wire gauge). Since an original Tek extender uses 58 thin wires, and only 4 thick wires and 6

I'm with Tom. I ordered the arcade cards first, then got two sets each of the TM500 and 7000 extenders from John. Much, much better IMO. Mark

Other possibles listed by DoD WEBFLIS include MAN10 (Monsanto, probably hard-to-find) and TIL302 (Texas Instruments) - try Lite-on for a cross reference. Mouser carries Lite-on, so their drill-down

Thanks for the links Dave Daniel.

Austin 10 1936, 3 landrovers (serie 2a from 1970, defender 90 V8 50th annyversary from 1998, a 90 Td5 from 1999) a Triumph speedtwin (1954) and a EML bermuda trike ( based on a 1998 Honda GL1500

You could look to see which other instruments Tektronix used part number 150-1018-00 in to widen your selection of parts mules. Also, you can reverse engineer the pinout from either the schematic

Tnx to the group for the suggestions on my DC504 display. I swapped one display digit with another & the problem followed the swap. So, the consensus of the group that it was a display problem was

Photos would be nice. -Kurt

Sorry for taking a while to get back to you on this. It seems it is time for me to add an S-6 manual to my binder of sampling stuff. Here is why I do not believe the blow-by matters in this

I should have been more specific. Actually I get about 9.3 MOhms on the 10x probe I checked. I am learning a lot though by thinking about this probe, reading everyone's comments and reading the

I picked up the M01 scope and took it over to the VintageTEK museum for a closer look. It turns out that before the 7000 series got its name Tek developed two products called the L01 and the M01. The