开云体育

Hi Jerry: I used the same PCB layout software to do the front panel. It is TraxMaker. All the dimensions for the PCB were in the software so why not use it for the front panel as well. I was pleased

Hi Jerry, Nice idea to feed the LV board with another power supply. You plan to use the rectifier outputs from a 7603 so you probably mean the unregulated outputs. Then the 7603 has no protection. I

When I get time ( yeah right !) I will do a photo tutorial of how to do this without the machine small manual can be done in less than 1 minute by hand a large manual takes 2 minutes worst case Dave

Both of them sell very similar moving boxes, but no shipping boxes. They are definitely not strong enough to hold a scope (if single boxed). They have only a few sizes. (If you are using them for

Hi Team, We got one at Lidl or Aldi , it is a bit crude, but for re-assembly, perfectly OK Cheers Paul

Thanks to all for the comprehensive, and very useful responses. I was searching for 'spiral' binders - wrong. Should have been 'comb' binders As my old Ma used to say; asking the right question

Spray foam seems expensive for this task. But there are packaging services with proper two part foam generators, specifically for packaging. I think that foam is more dense and there will be no curing

Just go into Staples - they have the binding machines and plastic bindings in any size up to about 4". The charge about a fiver (or less) to rebind a manual IIRC Regards, David Partridge

These are widely referred to as "GBC" binder combs. The machines to punch the 19 holes and to install the binder combs are often seen on eBay. There are both manual and electric powered machines

The binding machines that I have used are big and heavy. For me it wouldn't be practical to own one. I think the copy shop (Kinko's or other) is the best approach to fixing your binding. Don't know

Well, I replaced some broken binding posts on a DM502 yesterday. I took the entire front panel apart so I could glue the plastic bedding part together, since it was cracked (you know, "as long as

Chris Evil Bay has lots of em ...but most office supply places carry them....the larger ones (1" to 2" or 3cm to 6cm) are a little harder to find ...call ahead If you know the secret ( contact me off

Yes, I just copied an old Heathkit HW-20 manual by removing the comb and copying the manual and the fold-outs page-by-page. Re-assembling the manual took a long time because the pages were somewhat

Ok, I see Lyle is getting it.

I bought one of the mechanical perf/bind machines for short money "over there". Shipping cost as much as the machine !! But it works very well, up to a 2" spine. Just look for GBC Binders. 73, Dick,

A search for " plastic binding combs 19 " (19 holes) shows this for instance: http://www.binding.com/productdetail.aspx?id=6202021901 Albert

Is somebody in the SF bay area going to pick this up? I can arrange for a relative to get it rather then have it scrapped. Bob

ibico is the company that makes them here in the U.S. ? I have a couple perforating/assembly machines and lots of plastic comb bindings. You almost need?the machine to put the pages in the comb, or

I did a search on the web for "white plastic binder spines" and got quite a few hits, too numerous to list. I often have one of the local Kinkos bind manuals for me using black spines; never asked if

I get mine at Office Depot, but there are numerous sellers over on the "evil empire" !! Look for GBC Binders. 73, Dick, W1KSZ