开云体育

I was amazed, after looking for the proper screwdrivers, finding these bits were available as part of a set that cost about $5 dollars in the local store. I bought the set and it includes a nice

Hi Paul, I have bought many of those "sets" over the years and never found a Pozi bit. They may be a recent addition to the sets as the manufacturers of these sets seem to be competing over how many

Yes. I meant hardware store in the USA. And Yes! I know about and respect that we are just one country among many nations around the world. I consider myself fortunate that I live in a unique place

Pozidrive screwdriver tips are available in most DIY stores like Lowes, Home Depot, Menards, Harbor Freight etc.---if you know where to look for them. They are included in many of the multi bit sets,

George I started a new thread here with the correct model number which will likely draw you better attention You must have us partially confused with another dealer as we do not sell a "set" for the

Hi Andy, Here some more details. Maybe you feel unsure about waveform voltage levels. In Normal sweep mode, TP365 (the TD) is high (570 mV, my 7B92) during the sweep and low (65 mV) between sweeps

Thank you Dave - you are most correct - it was early morning - it is MR501. I have a few of your excellent scans and you are "in my back pocket". MR501 is not on your TM500SET which I have. I just got

George You sure about the model number? I can find no reference to the unit anywhere in the literature? Could it be a MR501 ? ( We have the manuals for the MR501 :-) ) Dave -- Dave Henderson

Does anyone have service info for this cute X-Y plugin scope? A schematic would be most helpful. Thanks George Plhak

That seems to be the way to destroy both ;=) In my 547s, some handle bar screws are PZ2, and some are PH2. You feel immediately that the wrong combination of bit and head is wrong indeed. Like Fred

A few years ago I purchased a "Security Bit Set" from the Cheap Chinese Junk Store AKA Harbor Freight, it has a number of Posi drive bits in it. Also HP used the Posi Drives in a lot of their

I bought posidrive bits at http://www.mcfeelys.com/pozidrive-bit . The bits seem to be good quality, do not round off easily. I used a posidrive bit on a Philips head screw where I could not get any

Just looked at some Teks, my 547 and scope mobile had philips, exceot the frontpanel seems to have some torque. The 453 had Philipd but the fan is nounted With pozidriv, the 7000 serie looked all

To be specific. I think you mean, hardware store in the USA. There is a wild outside the US, we use strange things like metric instead of Inch, Celcius instead of Fahrenheit ect. And so there are many

Here in Europe pozidrive is the standard for most mechanical screws. Mechanics screwdriver sets typically come with pozidrive, electricians sets typically come with philips, so we can easily get both

"Dennis Tillman" <dennis@...> wrote:

I am getting a Test 04 Fail 01 error on a 2445A scope and I have been through the cal proceedure four times. I keep getting the error but when I exit out of the self test, every thing works fine.

Tek used Pozi screws in all of their equipment as far back as the late 1960s. At casual glance they look like Phillips Head screws with four little marks at 45 degree angles to the slots. There is an

There are adjustments for the horizontal gain (for x1 and x10) and position and it is done in the Cal-01 process. The vertical adjustments are done in cal-02. A good read of the calibration section

Thanks for the responce. This id the scope I am waiting for the new U400 to arrive to fis the vertical compression issue. In the meantime I have been testing other functions. The vertical measurement