开云体育

No the original switches are not available. I went shopping on the internet with a sample switch in my hand and the measurements in MM. I then used gorilla glue to put the switch covers on. This is a

'tis a dainty beast! One that I'd give up a lot of my 500's for. Surprised to see it local. The seller pulled the item. I hope it found a good home. Ron

Howdy folks, ? Just wondering if anyone here is the one who outbid me on this: ??http://www.ebay.com/itm/120997502634?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649 ? Is $150 typically what

The sad part of the is its prominent mention of "...12 6DJ8 vacuum tubes....", which might appeal to an audiophile who would kill the whole whale for a few ounces of ambergris. 73-- Brad AA1IP

My offer to resin-cast them got buried in the noise from the 3D printer wannabees, and nobody expressed any actual interest. ?No orders, no offer of a loaner foot to use as a plug, and hence no new

What happen to the guy that could manufacture Tek4xx series back feet (or cable supports). Any orders were made/fulfilled?

Hi Andy, Did you already follow the Delay Time voltage in the Delay Pickoff circuit? My interpretation after looking at the schematics is as follows. Check that U355 pin 6 and Q359A base follow the

It says 100Mbit uplink, 100Gb Traffic. Not far from me but I wouldn't know what I would use such a server for. ST

I prefer slow over loaded with javascript, ads, login requirements, and too many DNS lookups. :) I have been thinking about using something like this just for fun although it might not be any faster:

Hi David, What a slow server (33 KB/s), but once downloaded your combined schematics are a great help when studying the schematics at the pc screen. Albert

"All arraignments would need to be made by you" Sounds too dangerous to me.

Anyone who is interested, I posted pictures of my scope and 'Digital Storage' option module under "Tek 465 with DS" on Photos folder on this site.

Yes I have but it won't trigger either. It looks like other than the triggering issue the storage mode is fully functioning (the markers seem to work, the various display modes, norm, enveloppe, avg,

I have no affiliation with the seller. http://www.ebay.com/itm/280998648258 -Kurt

wrote: I do not have a 7B92 but by comparing the 7B92 and 7B92A schematics, I can see how the 7B92A intensity and contrast controls should work a lot better than the single intensity control on the

I tried combining the cleaning up the split schematics from the PDF and placed them here: http://www.banishedsouls.org/c2df3757f1/7B92/ wrote: The mainframe Auxiliary Z-Axis Input is a low impedance

I have no affiliation with the seller. http://newlondon.craigslist.org/ele/3338986696.html -Kurt

Jerry is correct. Set the scope to its max sensitivity which does not involve switching a preamp into the circuit. Using an LC meter, such as the Tek 130, adj the scope input to read 20 pf (or

Jerome, Have you tried triggering while in storage mode? Jimmy

I'm new to these scopes, but have lots of programming/debugging experience. This program works fine with my TDS784C. I just got kernel file created. Scope has to be off when protection switch is moved