开云体育

Is anyone here bidding on this, and if not, do you think its worth pursuing? Item number 270282625252

I bought a load of these on ebay and some 7623/33/03's, 18 in all from a local university for the same price. It was within driving distance though. I would shop around some more.

Thanks everyone. My 535A has started misbehaving again and I was wondering if that could be the reason. Maybe it's an intermittent contact in the 1A1 edge connector. I'll have to investigate... --

Yes, the fan suck dust and fluff from the floor necessitating frequent cleaning of the filter - otherwise no problems that I am aware of. Geoff -- Geoff Blake G8GNZ located near Chelmsford, Essex,

Jim, Did you get my emails about non-delivery ... Regards, David Partridge

There's the 2246 operator's manual off this fellows page. http://www.chudov.com/manuals/ I've never seen the service manual for the 2246 available "free" online anywhere. (Though I wouldn't mind

http://remote.sqhill.com/tek-2430a.pdf thepinkfloyd67 wrote:

Are the measurements accurate for what you see, or is the trace compressed? Dave Casey

None in MA that I know of ESS in Manchester NH (Exit 6 off I-93N) take right off of exit and it's about a 1/2 mile on your left on Candia Road they have a substantial Ebay presence as well and you can

Hi, I hope this post isn't bad new for your but here goes: Make sure you point an external fan at the CCD when running outside the cover. Even 10 minutes of operation with the CCDs being cooled is

Greetings to the groupe, I have a 545 that has two or three graticuls of trace and the rest is blanked. How can I make more graticuls available?? Thanks in advance, George

I don’t think the 535A cares what position it is in as long as the air flow through the fan filter is not restricted. Stan _____ From: TekScopes@... [mailto:TekScopes@...] On

It is a 5082-3081, currently manufacturer by Avago. It is available in single quantities from Farnell and Mouser. Regards, Javier, EA1CRB thepinkfloyd67 escribi???:

I am in need of manuals for the following scopes: 475 DM43 2335 2215 2246 2430A TAS475 I need both operator and service manuals for these units.

Does anyone know where I can locate the following obsolete part? HP3081 If not, can you provide me with a data sheet that I can use to find a suitable cross reference? The part is not for a Tektronix

Just re-align the trace - But the elctrons will dribble out of the back onto the bench :) =Dan

bhaskins@... wrote: If you have more than one lab bench in use, some rack mount scopes can be helpful, even stacked up three high... At one of my two benches, I have a 2230 DSO on the left

Who in TekScopes was it that offered rubber feet for scopes. I think it was Howard something, but I do not have his last name or email address. I need some more scope feet. Ken

Hi Stephen, ? Thanks for the info. ? I'm not sure what Tekronix was thinking with a clock that needs to be reset every time you power up - seems pretty useless to me. ? I'll try cleaning and

That is a Tek part number, 151-0188-xx, which is a 2N3906. Craig