开云体育

As Ryan said, This equipment has been purchased, any yes, some will certainly be at the local ham fairs.

I just got some of these https://www.thingiverse.com/thing:4565400 3D printed in nylon from China. They are white but fit well and were cheap (6 for $8 including shipping (for some reason I got a

Hi All, The items are mainly TM500 / 5000 series plug ins and 7000 series scopes and plug ins... Most of which I believe were purchased from the Tek Country store over the last 2-3 decades. She

Funny, When I google ko4bb and click on Manuals, I can get to any manual that is a file listed on that page. But if I click on a folder, then it goes to Home page. Frank DuVal

Well... many of us...on this forum... IMO... are hobbyists. Probably, I am not very smart... but AFAICT... time, connectors, and fiddling around with shipping, can be expensive... but, high quality

Hi: AFAIK... there have been a few projects about/similar to this. If you have the time, and the desire... can you explain why they cost 150.00 each? -- Roy Thistle

[email protected]> wrote: The owner has been having capacity problems. Due to that I would only make sparing use of a

Does anyone know what is going on with ko4bb,com? If you click on manuals than any link it just takes you back to the main page. Sam W3OHM

Not to dissuade OP from their project but Dan Meeks on this list may still have some of his kits for extenders that were sub $50 USD last time I bought one [email protected]> wrote: --

Ditto on what Arne Buck said. Interest is for one extender board unless they get really cheap (< $50ea). Thanks, Tracy Tilton

I also had some years ago my right eye done. It took me about three hours in the clinic all in all. Perfect result. My left eye is only slightly yellowish like the right was but the color temperature

I wonder if that Lego 7K scope still exists somewhere.

I am glad to see this response. I am due for implants soon so its certainly of value to me. Missed my appointment due to flu but due for exam by surgeon in a couple of weeks. I have fairly

Greetings, I’m a little off topic and not certain if I intend this message for Clark F or Kurt R. Perhaps my comments may be a value to others. I was inspired to comment based on reference to

I would also be interested in R Allred

Very nice piece of tektronix history. Thanks to both of you.

A photograph that was used for the cover of EDN magazine was posted to the Tek wiki site today. The photograph was published in November 1982 to support the introduction of the 7D20 and to reinforce

Yes, I am interested to pitch in for one such extender board. I have a few 500 plug-ins that need attention. I have the 067-0645-02. Easy access to all connector lines, voltage and current, is a

Thanks Eric. For some reason the p/n and supplier is missing in my paper manual. Great info and thanks for the contact. I've sent the ebay chap an offer. Nick G0WEF

Hello Nick, The TEK reference of the switchs is 119-1161-01 ( DYNATECH FSCM 50667 - Mod 03 - 412C002 ) There is one for sale on Ebay : https://www.ebay.com/itm/135289792016 Best regards Eric