开云体育

Hmmmm… Seems like cold-shrink tape may come to the rescue. Made by Daburn Industries and Available from Digi-Key and maybe Mouser. Put some foam or bubble wrap around the metal handle and then

Look for heater hose at an automotive parts place. This one is not Tek blue but close: https://radiatorpros.com/catalog/product/view/id/5354?gad_source=1&gbraid=0AAAAACfza3oIShxzph-nbtZ-58F5q7bXo

Just buy some garden hose, remove all the yellow color from it and, shazaam! DaveD KC0WJN [email protected]> wrote:

What, garden hoses don't come in Tek blue? Harvey

Or a Tek HP chimera: Blue case, greenish beige strap cover...

You might consider a length of garden hose or the equivalent for an inexpensive replacement. Harvey

Hi Benjamin. I personally have not had any success restoring old tektronix handles. However there are a lot of companies who make equipment handles. Ones intended for audio equipment usually will work

Not with a tm503 yet, but most 5xx scopes. A method I like is wrap with leather and sew shut. I might have some spare tek blue handle material from other cases. Would need to be cut down

Hello people of TekScopes, I have a TM503 with a disintegrating handle. The blue outer sheath for the steel inner core has become brittle and ripped open. This just leaves the thin strip of rusty

Edward, First off thanks for your comment. This scope has other issues right now. I need to understand more about crt acceleration. But will go through a full calibration if I can get everything

Ozan, I took both of the hybrids out for inspection. I found an open trace on Pin1 and Pin2 of the hybrid that was installed on channel 2. I tried to repair the trace but ended up damaging several

Reg, This grp, no phoots attached to the messages. Like many other groups.io, please use this preoceedure to post photos Left hand column>> "photos" section: >>New Album>>name it>>drag or select

do you still have to sell a 7a13 (digital) and a 7d13 to sell?

I see some type of conic beam expansion going on. The gost image is larger in both the x and y direction. Guessing it's crt (acceleration) related. I would check every bias voltage going to the tube,

Hi Barry, If you look at hybrid schematic on TekWiki pin 1 is the mid point of a 845-ohm to ground and 1.21k to +5V. In your measurement Ch2 hybrid shows ~ 0.366-0.649V at pin 1. This means a current

I was going to attach screenshots from my 11801/SD-32 comparing one of Leo Bodnar's new LBE-1322 pulsers to the calibrator in the 11801. Seems I'm not allowed to do that. Don't know why or care.

Just to make sure it is Ch2 and not the trigger path showing up on screen for some reason, if you change trigger source to Ch1/Ch2 does anything change? ****When I change the trigger from CH1 to CH2

Just to make sure it is Ch2 and not the trigger path showing up on screen for some reason, if you change trigger source to Ch1/Ch2 does anything change? ****Nothing changes when switching between CH1

Hi Barry, Nice find with delay line. Just to make sure it is Ch2 and not the trigger path showing up on screen for some reason, if you change trigger source to Ch1/Ch2 does anything change? Are

Ozan, Select CH1 OR CH2 and trace shows CH2. I currently have a square wave going to CH1 AND A sine wave going to CH2. Regardless of the switch position CH2 is displayed. (Except when CH1-CH2 is