开云体育

My manual scan covers serial numbers from the beginning to at least 10760. During that time, the 130 used a 6BH6 for V110, Guard Voltage Cathode Follower. It was always a 6BH6 and nothing else was

Well, mine is actually a very old one... I bought it decades ago. Its much quiter because it doesn't run on nominal speed, the supply in the TM506 or TM5006 giving only 110V to the fan. The remaining

Will respond to you gentlemen when I get off of hell....er, work. Thank you so much. You are amazing.

Jerome, Are you sure the clamp tube should be a 6DJ8? I have a 130 (which I have converted to solid state) and the clamp tube is a 6BH6. Of course the 130 went through several iterations and your

I have also replaced mine a few years ago with one (220v) I bought from my local electronics store. I can’t tell you the make off the top of my head, but it’s much, much quieter than the original

bonjour à tous Have 130 LC since 1980s, from LLNL salvage was $0.30/lb, Still working fine, uniquely wide,capacity compensation 75,pF. generally the problems in older valve equipment is often leaky

I replaced the fan in my TM506 an TM5006 with 220volt Papst models. Mechanically identical, very quit. As to the airflow: as long as the temperature of the outgoing air is moderate I do not see any

VintageTek received permission to post the three-part article. See https://vintagetek.org/130-lc-meter-restoration/ There's also a beautifully restored manual as well. --Cheers, Tom -- Prof. Thomas H.

Hello Jerome In 2020 Silicon Chip magazine did a three part restoration feature on the Type 130. The link to the first part is https://www.siliconchip.com.au/Issue/2020/June/Vintage+Workbench

Hi Jerome, That's a nice unit and definitely worth fixing. V70 is a straightforward Schmitt trigger, and there's not a lot that can go wrong. Measure voltages on the tube pins. Measure resistances

Crap, pin 6 on the brain. Input of V70 is pin 9, output is 6.

Quick update here: It turns out that there are 2 Python modules exporting the name "serial", one called serial, one called pyserial. I had to do "Python -m pip uninstall serial", followed by " Python

Greetings fellows. Had this 130 for several years and decided to finally repair it. Replaced all the paper capacitors, and the filter caps. have little ripple so left them in. Powered up, the needle

I'm trying to get the Python program that John (Twilight-Logic) posted below to run. I was able to comment out the "termios" lines but now I'm running into a different issue. Python claims that module

I found these as NOS on E-Bay. I have No idea if they will fit the 7603 Rack mount. But I am thinking that they might just work. I have never seen inside a R7603, but looking at the manual the

Hi Bob, Thank you very much for your efforts. I appreciate your help. I will visit Tekwiki to see what is there. Regards, Ken

Bob, That control should work with the single knob. Let me know how to pay you. Thanks. Mark

Ken: The vintageTEK Museum has some microfiche, but it's likely it's no more complete than what's already on Tekwiki. I will check the microfiche when I'm next at the Museum, probably Saturday. This

Mark: Is it the rotating partial circle for "waiting"? it should come up eventually. If not I've uploaded a photo here: /g/TekScopes/album?id=272717 -- Bob Haas

Bob, I may get if if I can see the photo. The link you gave only gives me a circle on a blank background. Mark