开云体育

Dennis, Received book, guess just have to have extra patience when dealing with the Postal Service. Thank you for all of your extra effort. Eric, yes we are definitely in the same county. I’m

The guy that posted that ad definitively needs glasses, model was described as "233G".

I got at least one of the Canadian tracking numbers mixed up with another Canadian tracking number. These are the correct tracking numbers and their destinations and/or delivery status LH127124103US

My copy to Norway was delivered today. Much pleased with the quality of the book! BR. Thomas. ons. 20. jan. 2021 kl. 02:14 skrev momemeca <momemeca@...>:

Hello all! I've got a 7000 Series Standardization Plug-In 067-0587-02 that is acting strange. Sometimes the Gain setting on the TEST switch will show a compressed set of lines instead of the correct

Hi, Where is the service hours and power cycle statistic stored? Is it in the Dallas chip? I am about to buy 2467B which looks in excellent condition and was recently serviced. Since it shows only

On Fri, 22 Jan 2021, Mike Yepes wrote: Does it switch to frequency bands higher than 5? Bands for use with external mixers start with Band 6. > Hi, can Anyone help how to get higher frequency

Bruce, regarding your question about compatibility of this tester with TM5000 mainframes, I believe it should work. As I recall, the TM5000 mainframes can run TM500 plug-ins, but the reverse does not

Hi, can Anyone help how to get higher frequency displayed on this? Mike, KE6OJE.

Gary, Sorry to hear that - I thought you had your DDU repaired and that you booted from your DDU instead of the tape drive. I don't suspect the 4041 tape drive, although I would recommend using

At the back of the scope there is a BNC marked as A-gate. While applying your sine wave to channel 1, triggering on channel 1, connect A-gate to channel 2. Pick "chop". Move X-axis to see the

Thanks for all of your help. I have spent way more time and I'm out of my element and another O'scope for around $100 looks real attractive. At least this one is a parts source. I'm returning it to

Dave, Were you wanting a "SERVICE" Manual? Because this is an "OPERATORS" Manual. These are not typically used for repairs and do not always contain detailed repair information, at least not in any

Is Shawn (KJ7MX) on here? I'm asking in reference to the eBay listing for printings of the 2236

Monty: If only the engineers at Tektronix had created a boot ROM that was not erasable with age. My system is completely dead if I cannot run the AUTOLD from the tapes. None of my 3 tapes will work

Jose, it looks like the beam is being unblanked before the sweep starts. Maybe the Z-axis amplifier has a problem? Or maybe the trigger circuits? Maybe some interaction between the two? That

A big milestone is coming this spring for KiCAD (schematic/PCB software). this new version is a very powerful tool, and 6 adds microwave/RF layout features and a lot of other goodies. For everybody

Hi Have just obtained a new to me 7l12--it seems to work somehow--if filters-video span etc works--but dc feedthrough 150Mhz off--when tested with 50Mhz cal signal --it is located 150 off and span

Hi, Base of Q770 reads +6.090 VDC, while the base of Q780 reads +6.081 VDC However, the cathode of VR764

Hi Gang, I've done some cleaning of pots, and switches using Contact Cleaner. Behavior of scope did not improve that much. I've tried to visualize a Sine wave (5V 1kHz) on both channels and as you