开云体育

I successfully created a copy of the System Verification tape and tested it on my 4041 without the ROM Carrier and Program Development ROMs installed! Quite an effort - I received the 15 DC100A NOS

Greetings fellow trekkies: I have been informed that my email address, that I included in my note of June 1st, had the email address truncated after the at (the shift 2 symbol).? Please note the

Hi Sean, There are four indents punched into the bottom end of the aluminum can, punching into the plastic base and thus holding it in place. If you take a small drill bit or burring tool, you can

To anyone interested in this subject, Here is the THINGIVERSE Link to a blank front panel for the basic TM500 Plug in. https://www.thingiverse.com/thing:4268888 This should be able to be modified

We've been over this many times. groups.io censors email addresses so they can't be scraped by spammers. This is the same as what Yahoo Groups did. The only way around it is to spell out the

It was ok on my computer. I wonder why that should happen? Perhaps Dennis has some idea? Colin.

Hi: I have no idea how that happened.? Here it is again: reed714@... phone, after noon only714 838 6241

Steve, You are right! I just did another search and it came up. Michael Lynch From My I-Phone mlynch003@... 479-477-1115

Hi Michael When you go into the thingiverse article the front panel is there also, but needs cut out for the pull tab etc to be added. Steve.

Steve, I saw this in an earlier search of Thingiverse, I believe those are the top and bottom panels. I’m going to keep searching from time to time to see if anything else pops up. Thanks for the

I may have found a problem. C693 came in with a resistance of a whopping 1.3 ohms.

Exploring that link sent me down a rabbit hole! Thanks!

Reed Please write your email using the AT format. The program truncated your full address after the @. Thanks Menahem Yachad

Thanks to Harvey and Eric for their suggestions about alternative ways to get hold of the little round PCB adapters for 4-legged capacitor mounts but Jeff contacted me off-list and offered to order

There is an unfinshed one on thingiverse as part of an upload under "Tektronix TM500 module parts" that someone has uploaded, it may be a good starting point?

Has to do with how old they were, and that Tek (and likely everyone else) use a 6 volt Tantalum on a 5 volt supply, which was the recommended practice at the time.? I'd be happy using a modern 7 volt

Hi Melvin, How did you get the lamp module open? It looks very well sealed to me. Sean

Interesting. Tantalum caps are generally very reliable. The solid type (CSR style) is preferable to the liquid (CLR style) because the liquid types contain sulfuric acid and make a real mess when they

All, I will try to respond to this new topic as well. Looking forward to working on this project. -- Michael Lynch Dardanelle, AR

The corrupted SDS8202 was eventually revived with an externally-drive firmware update. I had full function back on the 4th rewrite, after making sure that any stored settings were manually