开云体育

Hi EJP, I can send you a new one for $15. Contact me OFF LIST if you want it at dennis at ridesoft dot com. Dennis Tillman W7PF

Hi Chuck, If you could wind a new HV transformer for the 7934 (as I understand it's the same one as the 7834), I'd gladly pay that for it. Thanks, Kyle -- KSR Amps / Rhodes Amplification, LLC Kyle

These are just toys for an old man. I bought my 11801 because of the CSA803A plots that you send out with your pulsers. I thought it was just *so* cool. I got lucky and picked up an 11801 with a bad

You can grind off the crimp where the outer ring holds a washer and a spring in place. Some can be clipped with heavy diagonal cutters, since the crimp weakens the brass.A cutoff wheel in a Dremel or

Brute force helps! I have a memory of doing it many years ago by turning off the peaned over bit at the back of the locking ring but without a lathe you can just start filing and/or cutting the ring

Roy sends. In filmmaking, the “gaffer” is the head electrician and/or lighting designer. I somewhat reluctantly add: If it should move and doesn’t, use WD-40 If it moves and shouldn’t, use

Hi Jim. You might want to check with Ron on eBay. His Id is Mercedesman6572. He has a lot of Tektronix parts. His email is mercedesmann@.... I have found him pretty helpful in the past.

'Gaffer tape' was a joke actually. I will use heatshrink tubing on it. I looked at the RJ58 plugs but cannot see how to get them apart. EJP

Am I the "gentleman" in the 576 thread? I asked a few questions, got the information and went along asking a friend if he could print the bobbin. Then out of scrapped stuff made a little manual

Hi all At the last swap fest I got a 555 scope power supply without covers. Does anybody have covers for this, or for any unit with comparably sized covers? I can provide dimensions for the covers. I

Thank you, larry

What are you going to use it for? I have two SD-30 that I use interchangeably that I have bought broken and fixed: one had blown termination resistors, another - faulty trigger pick-off hardline. I

Gaffer tape (or Gaff tape) is used in studios, sets and theaters for EVERYTHING.? It's like duct tape, but holds better, tears better, feels better, etc, and tends not to leave a mess behind if you

I have used some ordinary RG218 cable and BNC connector & left the shield unconnected on my 5CT1N. Works like a charm. Cheers, Magnus? Maybe it can be seen from here:

Hi Peter, Mine moves exactly one division too Vert Offset Horiz Pol Max Peak Series Resistor Left/Right 0.5mA 0 50v +NPN 1500v 3k (220W) off (no component) Turn the variable collector supply so the

The low 100 mV / division vertical sensitivity, a very low operating frequency and the shortness of the lead are the reasons why Tek did not shield this connection. Anything that completes the circuit

The picture does not show. I will attach. Note this is low voltage (1v full scale) and very low current in base and collector. [email protected]> wrote:

If our cores can be rewound that may make things easier? I would pay $200 for either new or rewound 453 HV XFMR done with professional quality. Doesn't make good economic sense I agree, but I would

Maybe it can be seen from here:

I'm sorry, I forgot that attachments are not allowed. I will upload it somewhere and I'll send the link. --- El software de antivirus Avast ha analizado este correo electrónico en busca de virus.