开云体育

Mike I stopped looking for the original style mounts years ago. I use a short length of rubber fuel line from the auto parts store and a machine screw. Works for me. If you want a picture let me know.

Hi Michael, Two things to help further your education: 1) there are almost always multiple devices in parallel, or series with every device you may wish to test in circuit. 2) Sooner or later you have

Am I still on the list for one of those 'scopes? Bob818 894-2887

Well I guess you get what you pay for. At $50 for a 2440 should have been a clue. So far the first 2440 I turned on has cal errors 4000 FPP fail 7000 CCD fail 8000 PA fail all others passed Maybe I

Chuck, Sorry, I was not at all clear, I should not have used the term "continuity" as I am using the Diode Test function on my DMM. To be precise: IC7 is open (infinity) in one direction (Red on Pin 2

Continuity means very little. You need to observe the voltage when you insert some current. To make this possible, most DVM's have a Diode test position on one of the low ohms positions, or as a

All: I have been studying this power supply all morning and doing some unpowered testing of various components in circuit. I have two optocouplers in this circuit. They are type CNY17-2 and I found

If these are the same as the three double-ended mounts used on later production, I bought a batch from McMaster years ago. I'll give you four for a token amount to cover shipping. I'm in Hillsboro,

Ravi, I will continue to study this circuit and the materials that you have suggested. Is it your opinion that UC3844A is the oscillator? The Data sheet for the device seems to indicate that it is.

Perhaps the input circuitry has been blown out by excessive voltage which is a good hint for what is wrong. I wish I had a schematic of what is in the unit before I cut into it. I also wish I were not

Maybe the cap IS leaking, and heated some of the resistors on the right hand side of the schematic up? After disconnecting the cap, the resistors cooled back down and found their normal DC working

An interesting change has occurred from yesterday... Yesterday, I removed C4403, turned the scope on, adjusted the focus and astigmatism, played a little bit, and concluded the dynamic focus circuitry

McMaster-Carr has them, as do others

The four rubber vibration damping fan mounts on my circa 1956 brown case 545 have disintegrated. Any suggestions on where I might find suitable replacements?

Hi Michael, I will check the standard circuit for and around UC3844A and provide my thoughts. The photo of your A5 board will also help in understanding component placement on the board that you have.

Hello everybody For the repair of my T912 i need 1 knob Volt/Division ((Tek part 366-1646-00) and 1 x the shaft that goes from its Variable 9red) knob into the potentiometer. I liven in Amsterdam

Ravi, I have became a student of Mr. Carlson's about two years ago, I have watched that particular video on SMPS several times. It all makes sense to me at that level. The board level is where I get

Hi Chuck, Thanks for checking that, so it's off my mind. I agree re. Q4432, Q4440, and all of those high resistance resistors in the focus chain. Interesting and intriguing! Raymond

I once carried a 7704A a little over a mile. I don't recommend it but I would like to point out that my ability to carry it gave out, while the handle is still in working order.