开云体育

http://w140.com/tekwiki/images/a/a0/Tek_2a63_irb.pdf http://w140.com/tek_3a6_irb.pdf These PDFs were by made possible by Deane Kidd and his family and friends.

Sorry about that, Mel.? Let me try filing down the epoxied bowed connector first.? Thanks. Jim Sent from my Verizon, Samsung Galaxy smartphone

That would be fine. The only other part that is difficult to test for me is the tripler module with the hv lead. If you like you can include that also. Let me know the cost and method of payment you

I'm perfectly sure it will cause "some oddities" - I don't dispute that. I'm just very wary about winding that variac up more when the display is already brighter than IMO it should be (although I

I would think that using a variac a1/2 voltage would cause some oddities. Other more experienced members will weigh in im sure.

Hi all, I'm really not very familiar at all with these exotic beasts. I'm powering up a 466 (early version) slowly from a variac (they used a linear supply on these) and at about one-half mains

Just use a different email address if you do not want this one shared. They are free and nobody else needs to be bothered to change anything and you do not have to rely on anyone else to keep your

Hi Mel, Yes, I did. I have been comparing it to what I already have and the documentation on the rigid and flexible extenders. It seems that it will do the job with a bit of fettling. My rigid

Hi Colin, Have you received the connector yet? Cheers, Mel -- you can never have enough oscilloscopes, DMMs, valve testers or soldering irons . . .

Jim, I haven’t receive your address yet - do you still want this connector? Cheers, Mel -- you can never have enough oscilloscopes, DMMs, valve testers or soldering irons . . .

Hi Chris,, As the HT module is quite a bit heavier than just the transformer, I propose removing the Tx and sending it on it’s own. The problem arises if it’s not just the transformer that’ll

After various private exchanges, it seems I am describing the way it should work, rather than the way it does work. In a properly implemented system of this kind, the emails should come as 'from

I see your email as part of the list server email I received. Is there some way you can be anonymous? With BCC?

Thanks EricJ, I should clarify that I am referring to the CC: list, if indeed there is one. More probably it is a BCC: EJP

Actually Esmond I am quite readily able to see your email address. You are with bigpond. --Eric Sent from my Samsung Galaxy smartphone.

Can I point out that the email addresses that are provided in the mail headers are only those of people who receive group emails, not of the entire group. So for example nobody could use them to

Panic over. It turns out I had the A Intensity control turned way down, and must have turned it even further down the other day. I never knew what the hell it was for actually, or B Intensity either.

Hi, I sent the following to the list a while back and didn't hear anything, so I'm trying again, just in case. :-) Having acquired a couple of panel-less X-Y scopes, I'd like to obtain the one-piece

Hello All I'm a new member and have several scopes. Current project is a 7313. I got the regulator board working and finally got a vertical to show on the scope. I cannot get it to put out a

My initial impression when I first read the original message was that this was a solution in search of a problem. But I kept quiet, thinking perhaps there had been some incident that prompted this new