开云体育

I think I have a few low voltage supplies to check before getting to the HV stuff. Thanks. Sent from my Verizon, Samsung Galaxy smartphone

No, no ticking.? ?The scope loks and sounds exactly the same plugged in to the mains or not, power switch on or off. Sent from my Verizon, Samsung Galaxy smartphone

Yep, set for 120 VAC.? I did move the jumper to Mid voltage. I will try a night light in series as soon as I can.? Thanks, Jeff Sent from my Verizon, Samsung Galaxy smartphone

Good to hear. Ive read that the 460 is known for leaky caps on the adq board. I just grabbed a working 460a with a screen that says "passed self test". For under $100. I wont pick it up till my next

I REALLY like mine! But I can't compare to any other DSO's; it's the only one I've used. I haven't had any problems with it yet, capacitors or otherwise. Touch wood. --Toby

Was the 460a an improvement over the 460 regarding the leaking electrolytic capacitors? What is the general opinion of the 460a? Thanks

Jeff, Jim lives, or lived near Orlando, Florida. I tracked down his telephone number last year, but I have never got any answer. It just keeps ringing, so the account was still active. I know that he

Hello Jeff, regarding your comment quoted below, As I mentioned, I was not quite sure about the DM43, but on the DM44 (that has differential Delta time measurement), what it does is alternating 2

The original coating used when iintegrating spheres wee first used was barium sulphate in an emulsion. recipes can be found in the early literature. Bruce

First build/acquire an integrating sphere. Bruce

Turn the 7603 off, and then unplug the ht lead between the multiplier and the CRT (somewhat carefully! You may have to undo the P clip that holds the plug/socket to the end of the HT chassis to get

hi, LED measurements are made with a strict geometry & equipment; and accurate determinations are not always trivial. Some useful web sites with information are found at NIST (US) & NRC (Canada) as

Hello from a long-time reader and first-time (I think) poster. I recapped a 2465 two years ago, after which I got a clear, crisp trace. However, about a year later, the horizontal sweep stopped

Whatever happened to Jim Yanik. On Usenet he was the preeminent authority on Tek equipment. I guess he worked for them for about 100 years. I mean if you posed a question, once I did, 7063 with such

Yes, but we must know if there is a HV fault. Hope it's not the multiplier. But we do need to know if there is B+. I figure the best way to proceed, once it is established that the low supplies are

Mike Merigliano 5:37am #149175 "Okay, but I did not think the posts about the Tek 475 had anything to do with Bob's computer, so I would have never guessed this." Hmm, the quote function didn't

Hello Dmitri, Fabio here again, On my last message, I was mistaken about the DM that ou have. I looked at it briefly on my mobile and thought it was a DM44, but it's in fact a DM43. I`m not sure how

The integrating cube sounds good if sufficient. You can improve the uniformity and efficiency to arbitrary degrees by adding more surfaces, say starting in the corners, making it k-hedral, approaching

Hmmm- I need to make a Costco run today anyway.? I wonder if Mountain View, Sunnyvale or the Coleman store have them.? I would think so as they are more universal than certain food items that only a

Integrating spheres, even on ebay, go for silly money but there is a way......... I wanted to get the spectrum of an NVIS compatible illuminated switch and actually got pretty reasonable correlation