开云体育

Please put the link here also.

Hi Craig, You can easily build one in just a few hours. The only challenge is obtaining the right tunnel diode (eBay), mounting it (use conductive epoxy), and confirming the rise time is within spec

Looking for a working condition Tektronix 067-0681-01 Tunnel Diode Pulser for doing the Cal 6 on a 2400 series scope. I have all other tools but am missing this tool to complete the full calibration

Got it. I donated $25. Thanks for the pointers and of course, once again, for everyone's help on this forum for the last year. I'm a newcomer to the space and am somewhat overwhelmed by the generosity

Sorry for not replying sooner Tom, but yeah, they appear to be the same ones. A fellow Tekscopes member, Dave Wise, is sending me three of the mounts. Didn't figure McMaster would have them, so I

The home page, blog, and YouCaring site all say that monies donated above the goal will help to improve the infrastructure for the scanner. This would be improved networking, new computer, and new

I have much enjoyed the recent discussion here about the 7T11/7S11/7S12 sampling plugins and have learned a lot from the contributions. I have a long-term quest to get my Soviet Ya4S-100/Ya4S-101

Necessary: No Appreciated: Yes

Harvey, thanks for your example. I do somewhat the same with a voltmeter in respect to measuring voltage drop/gain rather than doing the math, I can get higher resolution too since the decimal moves

Thanks... I just finally had a chance to go to the VintageTek home page and it says the goal has already been reached. So, I'm trying to ascertain whether a donation is still necessary?

SOLD OUT

Jeff, thanks for the example. A question, I believe I've seen with this type amp, push-pull IIRC, where there is a common 'center' rail, where that voltage is 0, and there is a negative voltage for

I have a cover for my recently purchased 2213A- I tried not to reveal my delight to the seller :-) Anyone know what other scopes it would fit? Measures about 13x5.25 inches. Not sure I'd want to part

Thanks to all who responded to my question. Yes, I had in mind the waveform generator and not the LOGO generator. Reasonable cost is in my mind is less than $100. They are now hard to find the

I'm using a pg506 and adjusting the trimmer right next to C134 the schematic has a pretty clear picture. Albert Otten 3:53 am #148118 In theory with a 10X probe the sensitivity of the front corner

In theory with a 10X probe the sensitivity of the front corner amplification is nearly doubled compared to using a normalizer. So don't expect to see more effect with a normalizer. Are you sure you

Send me a picture, Morris-if you can. Just need something to roughly ID them. I have a box of old 535/545 bits and pieces I nearly tossed recently but conscience got the better of me (fortunately)-

Hi all, I am in need of the two “Graham Cracker” resistors for the vertical amplifier of a 535A. They are 1.3K with two taps. If anyone has a couple of spares or a 535A carcass that can be a

I have one of those as well, but I think I paid more than $40, but much less than the outrageous price.? The QAM is interesting on an analog scope; I don't recall trying it on a digital scope.? My

Try searching the group files and past messages for the test circuits.? There should be at least two schematics available, because I built one of them, and almost built the other.? I think the one I