开云体育

Thanks for your perseverance ;-) I get it now. That's bad news then.. means they will never ever release any schematics. I wonder though, why they were not "scared" or releasing their schematics up to

I would like to donate $25. How do I do that? wrote:

akhilaadepu143@...

akhilaadepu143@...

hi friend i am joining in your this is first time, so i don't know how to give reply so please understand me my email ID is rajuadepu009@...

hi friend i want join in your groupe

Hi Vincent, As an original member of the museum I thank you for your donation and for raising the importance of the museum and the work it will be capable of doing when they start scanning all those

I think you have it backwards. It is very hard to look at circuitry that one of your engineers creates, and know for certain that it is free of patent infringements. Most engineers are likely to

Hi Chuck, Thanks for that... didn't occur to me :-( So in short, the patents that Tek filed originally with the intent of PROTECTING themselves... is 20 years down the line playing AGAINST them ?

Hi Vincent, It is all much easier to understand if you are a money grubbing, scoundrel thief. In a word, the reason they won't make the information available: lawyers. If they show you the source code

Fabio. There is no way a simple 33 ohm resistor could cause that... pshhh... HAHA. Nice job!! /g/TekScopes/photo/49370/7?p=Name,,,20,1,0,0

Yeah, I am not a librarian so if you say it costs so much to stock all their paper/printed manuals.. well you certainly know what you are talking about, it's your area of expertise after all, dealing

Just made a little donation (35, not a US citizen so not tax deductible...), every little helps. Been a month and a half and I see only 90 people donated ? Despite the important number of members on

Hello Lop Pol, Well... Attenuator blocks are not really swapable "Plug-andPlay" as they are usually adjusted to match each 7A26's input capacitance... But, since the behavior is consistent and the

When I replaced the bottom half of the probe body, the replacement part did not have an opening to allow adjustment of the DC offset Trimmer. I disassembled the probe and drilled 1/8" hole in the

Hello, I didn't see that you got a reply to your fan mount question yet so let me 'take a swing' at it. The manual for the 180A does not show us a picture of the fan mounts, but they might be the

On Fri, May 18, 2018 at 02:24 am, cmjones01 wrote: > > On Thu, May 17, 2018 at 10:16 pm, lop pol wrote: > > Messing around today after i THOUGHT i had things straighted out, I was > > looking at the

If it's only happening on the 20mV/div setting, it's probably something to do with the attenuator compensation capacitors. These are also prone to problems, though I've found that it's not so much the

But you must pay close attention to your return address or you will end up sending mail from the wrong address. Ask me how I know. I have 3 e-mail addresses with Yahoo and I use Thunderbird as my

Messing around today after i THOUGHT i had things straighted out, I was looking at the rise time again and 50mV is good 10mV is fine but now 20 mV only has horrible rise time. Do you guys think that