开云体育

'Dennis Tillman' dennis@... [TekScopes] wrote: Most have never used anything better than the Huntron, or other low grade device. They are shown the one use, and that's it. I had to show

Hi Michael, Yup, as I suspected, a signal (1Khz sine) into the X input gives a full width trace across the screen and into the Y input gives a full width vertical trace so it looks like both the

On 12/16/2014 09:18 PM, 'Michael A. Terrell' mike.terrell@... [TekScopes] wrote: > > My troubleshooting is to always inspect & test the power supply, > then break the problem down into

Just letting you know there are currently a few of these left on ebay, in case you need one for your Tek 2335/6/7. Just ordered one for my 2335. Tektronix 155-0220-00 Hybrid IC, vertical Amplifier

Any curve tracer (even the venerable 575) can do everything a Huntron Tracker can do. In fact a Huntron is just a simple one parameter curve tracer. The thing that surprises me all the time is

Steve Ditter mentioned Bob Pease' Improved Short Circuit Detector the other day so I hunted it down. It is quite simple, portable, battery powered, and provides audible feedback as you get closer to

Make sure you check all supplies are inside spec for ripple with your loaner scope. One plausible cause for false triggering is PSU ripple. Good luck!

Some inexpensive oscilloscopes (B&K? Hameg?) have this capability built in.

Keith Smith kahsmith@... [TekScopes] wrote:

Great idea on using the X-Y mode. I'll give that a try! Steve

Well, thank you! -and I'm not kidding. I wanted to ask about these things a year ago, but it did occur to me that I might get kicked off the list! If I haven't revealed my complete newbie-ism yet. I

The underlying idea behind the Huntron Tracker is an old one and there are many circuit variations on the internet if anyone is interesting in building one or adapting their scope to do the same

The trigger light does come on in P-P auto but of course, no trigger is present. I can get both channels to put a spot on the screen and both will move both vertically and horizontally with the

ultrasport@... [TekScopes] wrote: Can you feed a sawtooth or other waveform into the horizontal amplifier? Put it in X-Y mode and feed it into the X channel. You could use the calibrator

Tom's settings are good, I'd add turning up the intensity for good measure. You are correct to consider the trigger circuits as the problem in addition to the timebase. no trigger equals no sweep. If

'Dennis Tillman' dennis@... [TekScopes] wrote:

Hi Tom, Since I have no sweep, I have no waveforms on any of the pins you mention. I am now checking resistors, diodes and voltages on all of the trigger and sweep circuits but so far, I haven't

Hi Keith, The good news is that you can list your Tracker on Ebay for $400 and get most of the money you paid for the entire lot back. Dennis Tillman W7PF

Hi Mike, For many years I searched Ebay for a Huntron at a reasonable (<$200) price since, I thought, I must be missing something important. Fortunately I never found one at a price I could justify.

Hi Steve, I know very little about any of this... but.. I was just experimenting with a 2215A and a 2235A that had the outer covers off, to see how they acted and what I could easily check. Using