开云体育

I like my Mk 1 thermometer.. nothing better.. you just have to be sure to wear your Mk 2 rubber shoes and no ground straps when using your Mk 1 thermometer.. JM ________________________________ To:

Hi folks, ? Thanks for the silver cleaning advice, particularly to Chuck Harris for the Tarn-X suggestion. ?In the end, it was more elbow grease rather than magic that got my adapters cleaned.

I double-dipped on my motorcycle ignition AND exhaust manifold, yesterday. What doesn't kill you... ;) Bernd

Of course I have the occasional attempt to zap myself, just to remind myself not to do it again. My latest was in a professional power amp - transistorised, but capable of 600W per channel into 8

Hi Azzy, HP characterizes the 8656B as the least costly of an "economical" signal generator line. Note the top frequency of 990 MHz, 10 Hz frequency resolution, and -127 dBm minimum output which are

...and, most likely, the same 8 lives would have been "saved" if those 8 idiots had had sufficient common sense to survive! Natural selection at work, seems to me... evolution has come under the

Thanks for the link, I looked at the cal manual. Jesus! I doubt if I will ever have the patience to sit through all that. The unit on offer does not have precision ref but I do have an Efratom FRS

Well the 318 and 338 has a serial interface, as in serial port. Tektronix recommended to be connected to one of their terminal machines.

Gala I only have a 308, and that doesn't have a serial port, what it has is a BNC connector which you connect to a single data line of serial data using a regular 'scope probe (P6107). Other than that

Anybody knows were I can find the protocol used for interfacing with Sony/Tektronix 3x8 logic analyzers through RS232 ?

<http://cgi.ebay.co.uk/321075670023> Sold with a 7A16P rather than 7A29P though. The seller has also written a nice program to control it and display the waveforms. Regards, David Partridge

I've a Tek 2445A scope with failing U800 (155-0241-02) I know, this part is difficult to get. In the files section, a document about a U800 replacement module is given. Any more information for

<http://www.eevblog.com/forum/testgear/agilent-dsa-x93204a-33ghz-80gss-teardown> Regards, David Partridge

Sounds like the deWalt battery powered drill I bought a couple of years ago (in the UK - so subject to EU safety). The "manual" has all the hazard warnings embedded through the instructions for use.

Hello Patrick, Again, thank you for your help and advice. I bookmarked Qservice.tv, thanks. I will check the list of caps against my schematic before I order parts. I will probably update the

To do a full calibration on the 8656B, you will need a good SA such as the 8568B. There are notch filters that need the be adjusted using another sig gen and SA. A counter and a good frequency

Thank you everybody for the input. I have been offered an 8656B locally. What do you think of this one? Short of carrying my 494AP and attenuators to the seller, what could be a simple method of

Hi Mac, I recommend that you add qservice.tv as a favorite in your browser because you can get lots of useful information about Tektronix scopes there. For example, you will see that the part number

David, I suspect the tunnel diodes were ok, since replacing them didn't change any symptoms or offsettings needed to compensate. I really don't want to put the originals back in to find out since this

Wow, thank you guys for the warm welcome and help so far. I am definitely encouraged and right now I plan to restore the machine. So here is a brief status report. I looked everything over good inside