开云体育

Is that a selective voltmeter? My dad has a working one methinks, but it's pure luck: no schematics. Kuba

I'd say that some older three digit scopes done in discrete technology would fit the bill: you could possibly substitute more modern transistors if some would blow, and the HV transformer can always

Hi John Did you check the suitcase as baggage in the cargo hold or as a hand luggage. I am not very familiar with these 2335 / 2336. I want at least 100Mhz and easily serviceable scopes without a lot

The new year brings with it some very good news for those of you have a Tektronix 2710 spectrum analyzer. Tektronix is once again offering calibration and best effort repair support for the 2710

Moe, I have taken a scope on business trips before. I took a 2230 several times. I wrapped the scope in bubble wrap. The scope was then placed in side a hard samsonite suitcase. It was no worse for

Hello group I would like to carry a scope or two on the plane to Myanmar / Burma. I don't think there are many TEK scopes there. Me being brought up in a Socialist / Military country in third world

Makes sense. I'm a big fan of maxima -- it's perfect if you don't want to waste time on symbolic computations. At the price, it can't be beaten. Cheers, Kuba

Ken, Just a guess, but it sounds like a loose pin connection at the CRT. You could try shorting stages from the CRT back and see where it goes goofy. Bill kenfrankmccabe wrote:

kenfrankmccabe wrote:

All voltages are good. Al other functions seem OK. I can move the trace up toward center and then it drops down about two centimeters. Happens with both channels. Happens in xy mode. I downloaded the

Sorry, that should read : Messempfanger, not Messemfanger.

Is there a group for enthusiasts of vintage R&S equipment? I have a problem with my Messemfanger...............................Don C.

componenx wrote: http://www.asvaro.org/efm/ Just FYI... Located in Cupertino, CA down the peninsula from San Francisco. It's a whole lotta fun and plenty of old tek gear if you come early. I saw a

Someone had asked about the amphenol connectors on the power cable for the 555. There is a guy that is always at the DeAnza swap meet who has some of the these connectors, hoods and all. I bought an

i always hated memorizing alot of math "forms" and grinding out long equations. im still into making the final adjustments on the test bench. before personal com,puters. unless you had a way of

Please edit any posts/replies to the list to minimize quoted material to that required for continuity. Please do not send personal replies to the list. List replies go to the original sender by

We used the Standard Amplitude Calibrator on the bench in Test-Final to cal the instruments after being cycled. There was no proceedure known to me that used the amplifier section of the SAC and I

I think there was more to it than simply omitting the amp. Stan has several -00's in which it was deliberately removed. This has always mystified me. Perhaps it failed to meet spec so egregiously that

Hi Does anyone know what the primary resistance is for T620 is. The power supply in mine doesn't work right. I have 500 volts at the plate of the 6dq6 and the thing is oscillating after I replaced

012-0649-00: CABLE ASSY,RF; 50 OHM COAX,28.5 L SMA BOTH ENDS "MEETS REQUIREMENTS FOR TYPE RG-223/U CABLE AS SPECIFIED IN MIL-C-17D AND MIL-C-17/84." This is a purchased cable, so the _exact_ cable is