开云体育

Re-ran the 2ND LO diagonstic at 100, 200, 500, 1000, 2000, 5000 and 10000 Hz/div span, the following was recorded TUNING FAILURE - 2ND LO - VERY FREQUENT Hz/div span TV Nominal DAC set 2ND LO

Suggest you get the exact service manual for the model and serial number of the scope Most HV trim pots and control are megohms not 250 Ohm Jon

I am looking for the VMT control software (and/or any other software) for the vintage 1996-1999 VM-700T NTSC/PAL video test set. Since this unit has been made "obsolete" by the sunset of the old

The test (previous post) was conducted at default power-up settings (1.8 GHz band, full span). I'll repeat the test with narrow spans reflecting the sweep I wanted to run, and post the results.

Have had this 2755AP for 10+ years; for the first time in recollection I've needed to use very narrow span width (to inspect output of a HP synthesizer). Frequency being inspected is 1000 MHz. When

Just a guess, but after some digging I suspect there is a different HV board layout/configuration for the 2 different CRT's available... anyone has any insight? Regards, Barry

I can't even tell what is the latest circuit configuration. Anyone have an idea?

One thing to check is whether one of the horizontal plate connections isn't, well, connected. They're easily pulled off, so take a look around the crt connections (not at the base, but where the plate

I hope I can too, it’ll give me a reason to set up a dedicated 500 series calibration bench, something I’ve been meaning to do. Right now I’m sitting on 17 1950’s/1960’s scopes.

Hello, my names Andy AKA Diabolical Artificer. I build valve amps & interested in vintage tech as well as using a 545B daily as my main scope. I also have a 585A & currently trying to get a 547

Greetings! I have an SC504 on the bench. What is the 250 ohm trimmer pot that is on the Hv Board? I can’t find any documentation on this mod. Insight would be appreciated! Barry

The VERTICAL POSITIONING pot looks to have been completely, and very cleanly removed. The violet striped, red striped, and black orange brown striped wires that (I assume) went to the pot were cut

Hi, no I meant modifications on the 465. During the years of production problems in the field can occur and as result modifications to improve the performance and reliability, quality etc.

A tiny update... The 2236 is successfully apart. I did find the CH1 probe sense problem, apparently TEK forgot to solder the W9100 connection on the A3 board, the wire was in the PC board hole, just

True. But, it's not the same is it. Here you are... pretending... and fantasizing... about being back in the day... of vacuum tubes and zinc plating... when what you are holding in your hand isn't

Well... I hope you can get it. You'll have to find the head/probe... or construct it..not hard; but, tedious. IMO... it won't satisfy someone who is new/newer to electronics: even though it is a Tek

Just the knob or maybe a parts unit? Thanks! Marty KL7AM

at a flea market? doesn't make sense. -- Roy Thistle

Only if you pay for Terapeak... Ebay's for pay, marketing tool, that shows what items actually sold for... which can be surprisingly less than what the listing indicates. otherwise it's just Ebay

Greetings, What is the recommended substitute for the WG1306 diode? 120v 150ma trr=4ns Barry