开云体育

Good deal!? I think we've taken this far enough off topic. ;)? To bring it back to Tek scopes, I am in the process of getting a hold of an 11800 series scope on the bay and selling my Atlas Sound

HI Guys Just thought I would mention an option for selling/buying gear in Australia/New Zealand (only) that does not have any fees at all! VK Classifieds (vkclassifieds.net.au) has been around for

We were lucky enough to buy an empty lot, and have a house built on it.? The builder was just at the point where they would still consider custom modifications, so we put in a few, mostly having to

I repaired one of these not too long ago, the video I made might help. https://www.youtube.com/watch?v=Tx6DtLooCOs My unit had drifting carbon composite resistors that were replaced, the usual sticky

If the 555 is being fed with the right Vcc and the other components are ok (did you verify that the pot was working?), then you should see a clock output. Finding a 555 is trivial, so you should have

I was in a surplus store today in Melbourne, Florida and found a nice looking, CLEAN, rack mount 561A that is for sale. It didn't appear to have been drop kicked around the parking lot or left out in

Funny you mention wired Ethernet, because I have my 3 computers, my work laptop, my home laptop, and lab tower, on a wired router.? All other computers in the house are on wireless, but my 3 are

We've been working a long while to get a house that's even halfway setup for hobbies, and this is.? Wired ethernet in every room, RG6 for cable, etc.... Naturally, of course, it's not big enough....

Nice setup, Harvey!? Well, we have 2 teens in the house. So they each have their own rooms.? Then there's the master bedroom and a 10 by 10 foot room for computers, scrapbooking, musical

This is a multiplexed display.? There's a switch/transistor applying power to each of the displays in turn.? That same switch changes the input of a single decoder to the various counters, likely

+1, Thomas!? ? ? ? ? ? ? Jim Ford (unfortunately living in an earthquake zone)Sent from my Verizon, Samsung Galaxy smartphone

I am looking for either of these CRTs for a 465. If you have one, let me know. Mark

Sorry for hijacking this discussion, but i'm working on a DM502 as well and wonder if you all could help. The unit powers on and has +5V and +/- 12V (step 1 of the check/adjustment procedure) but I

My wife has two bedrooms her own, for knitting, gourds, and whatever she wants.? I have one for a lab.? I also have the (shared) library for my books, TV, and recliner.? She has the family room for

I feel your pain, Dan!? If it weren't for my wife, my house would be full floor to ceiling with test equipment and musical gear!? OTOH, if it weren't for me, the wife would have it full of

My 2 cents. Politics does not belong on the TEK web site.

For Real..... Step 3: Stop building homes and factories on historic flood plains, in areas prone to earthquake or landslides, and on sea coasts that have been under water as recently as 10,000 years

That's why I linked you to a card that slots into a PCI slot and provides you with a PC/104+ connector. At which point the sky's the limit with inexpensive, powerful motherboards.

I would guess that the horizontal drivers are bottoming (or topping) out.? This suggests a power supply voltage is off.? That it suddenly goes "good" then back again suggests that the *effective*

I need some advice on where to start looking to track down a compressed sweep issue on a 7904A I was given. The sweep is compressed by about one division on each end and it does not matter what