开云体育

Yep - I replaced them all just for good measure!

This is Very Good advice. I would not go into a scope and just replace one of the caps. They all can easily be in a similar condition in the near future. -- Michael Lynch Dardanelle, Arkansas

While in there you might want to replace all the caps that where listed above, so as to future proof the PS section some more. Use nearest value and voltage equal or higher. Modern caps will be

Hi Ondrej, see that post: /g/TekScopes/message/157201 The shadow / flare effect is explained Bye Max

Sorry that should say "and I noticed the 33uF/160V on the 100V PSU output WAS DAMAGED, I REPLACED IT,...."

Good news! I replaced the PSU filter caps, and I noticed the 33uF/160V on the 100V PSU output, and it's all good! Looking at the base of this capacitor, it was quite obvious that it was the failed

Hi, I've been working on a 603 XY and began by recapping and testing on Variac, which cleared up display bloom and a squiggle. What I have now is: * a somewhat defocused (2-3mm), very bright spot *

Hi chipbee40 Yes, I am on 220v Thanks

Hi chipbee40 Thanks for your concern and suggestion. For c906 I had replaced by 100uf 450v type. And now I checked out of the circuit the esr meter shows 98uf and 0.34 esr. Thanks Saroj

I have two of these: http://w140.com/tekwiki/wiki/106 Now obsolete for my purposes as I have a couple of Leo Bodnar's marvelous <40 ps units. If anyone is interested in them PM me and I'll take

Hi Max, Any progress? Today I used an S-52 on an extender, case removed, and then thought of your problem. I read your first post once more: The 1N3130 is a 50mA/25pF TD, while the original one is

I see a couple of spiders plus some styrofoam. --Victor

I don't see in your messages where you have checked C906? Usually if 2 bridge rectifiers fail it burns out C906 (Large can), so you get rippled volts going through the power supply causing damage. I'm

Hello-- The books are sold-- my thanks go to everyone who inquired. 73-- Brad? AA1IP

- David Berlind5:16am #168839 --Somewhere (it has been a long time since I saw it), there's a video showing the cheap construction of the Chinese variacs [sic], the inaccuracy of the dial and the

Hi Leo I put on the scope without limiter bulb, it took away q9070, cr901and cr903. Fuse also blown away and ac mains tripped. I could not see any obvious short circuit near Q9070. At the beginning,

It puts a smile only face reading all these "made in the US of A" comments :-) versus "Made in PRC" I'm really happy with my Dutch, Philips made, insulated adjustable transformer, which, IMHO also is

A friend once sent me a smallish meter from Aussie land.? When I opened the case there was a humpty great spider in residence. Fortunately, it was dead. My friend was horrified !! I'm not sure if he

Somewhere (it has been a long time since I saw it), there's a video showing the cheap construction of the Chinese variacs [sic], the inaccuracy of the dial and the readouts, and the need to implement

Sorry to push the limit Dennis but I had to add an Aussie perspective ... we don't have a problem with critters in our cars. The snakes will get them: