开云体育

Spoke too soon... there was one on FleaBay, shipped for $32. Pounced on that, like a duck on a June bug! Phil

Well, during the reconnoitering to figure out where the black wire would be reconnected... the already too short red (actually, orange) wire broke yet again!? Now, it is too short to solder to. Why

Reed, Thanks for the input. Matt

It's odd. I'm on a number of groups.io lists and the only time I've ever seen a dupe was when someone resent their own message. But on every one of those lists there are a few people that have

Hi Matt: I removed two of the screws on the power transformer on my 575 and put two 3AG fuse holders, one on the side of the transformer and, the second on the front of the transformer. Slightly

When you reply to the groups from your email provider for instance yahoo.com, rather than at the groups.io website, Yahoo (or whatever you use) records the message you sent, but groups.io also sends

I have contacted Tech Support to find out the cause and how to stop this if possible. Dennis Tillman W7PF

Interestingly, I needed C-clip pliars, too, to remove the armature from the fan motor in my 453... bought a Craftsman that had a bag of different size pins. Worked a charm. Phil

Greetings, Allow me to suggest www.mcmaster.com<http://www.mcmaster.com> (McMaster Carr). They offer a variety of sizes under “snap ring pliers” and “fixed tip retaining ring pliers”

Thank you, Dave and Robin for your input.??? I will check it out. Phil

See? What's going on?

Why are my posts coming through twice? Does anyone know? This seems to have started happening recently although I have changed nothing wrt my email client set-up. DaveD

Excellent. Enjoy. Dave

Awhile back, I bought a set of circlip pliers made by Vise-Grip which came with several different sized tips. I think I bought them from Home Depot, but I'm not sure. Here is a link to the Irwin

Funny, last night i needed to remove c-clips from a hp331a to lube the gear shafts. I found the same thing,my pliers were too big. I ended up using 2 picks from a pick and hook set.

I'm looking for a good tool to remove the c-clip from the retention shaft from letter-series plugins. For example

Rolynn, I have removed the side panels and cleaned out some of the dust. In regard to the possible location of a couple of added fuses, in front of the fan, I have a couple of selenium rectifier

Phil et all I found a later change page dealing with the fan wiring ( non trivial change) and have uploaded the change page to the file section. hopefully this matches your unit. The change page is in

The manual that I have is three wires. I’m wondering if one is chassis from the case. Time for an ohm meter and check what the resistances are. Two should have the coil between them. One should be 0

Hi Dave, Yeah, there's a cap involved, for sure... will have to research is... tomorrow! Thanks, Phil