开云体育

Leave it alone. It does no harm like this. Not a problem IMO.

Usually, the pins should be neither bent asymmetrically, nor straight (like they are in your other picture). The vertical deflection plate wires coming out of the CRT neck are very thin, soft, and

While I'm not an expert on the 2465B AT ALL, I wouldn't worry about the bends and I wouldn't "fix" them.? While they probably could take an adjustment to realign them, they might have already been

Hi again, I shot 4 better images: http://crypto-museum.org/TEK/2465B_CRTPIN.pdf first 2 suspect bernt pin uint, last 2 another normal unit. Really hope the veteran 2465Bers can comment! Bon journee,

Hello all: Here is a photo of the CRT VERT plate and term in a newly received 2465B. the area around the term is VERY delicate and affects Vert transient response. I have NEVER seen a CRT pin bent

Ok. Thanks all. Confirmed 485 sucks. In at back? Sent from kjo iPhone

Doesn’t that contradict post 1478-2b? Sent from kjo iPhone

I wrote up a bunch of stuff about my TDS544A repair in the group, through several messages. This was maybe four or five years ago, before the move from yahoo, I think. I haven't had much luck

Hi John, If it has a Tek logo on it this is not off topic at all. We collect, support, fix, and recommend anything made by Tek. Dennis Tillman W7PF

OK that was a mix up. I accidentally posted to the Tek576 curve tracer thread. I am repeating it here in the correct thread so it can be found. Hi Ed; I sent you my repair log and in it you will find

Anyone looking to buy a MDO3054 scope. I have a spare unit with all accessories. It is a really nice scope. Check Tektronix site for specs. Contact electronixtoolbox@.... Craig

OK that was a mix up. Two threads crossed and this was meant for the TDS644A thread. And of course the capacitor was 47 uF not 47 ohms although the ESR is 7 ohms on the one removed.

Hi Ed; I sent you my repair log and in it you will find that the reason the first transistor blew a year ago was high ESR in C17. I had replaced the Q9 and both TVR (VR4 & VR5) and Q9 immediately blew

John, I am no expert here, but i have bought two AWG20xx series one 2040 and one 2020. Both were sold as "good, working" both had serious issues when they arrived. I paid top dollar for both and was

I have looked at other Tektronix groups but they are extremely small (one had 71 members). While I agree those 71 might be experts it is unlikely. So here goes an off topic question for those with

Peter, The DAC is Described in the manual on 3-9, it is built from discrete components. My 576 had numerous Axial Electrolytic caps bad as well as the Power Supply filter caps Some of the caps

Hi everyone, The "Limited Viewing" light, like everything else in a Tek scope has to be calibrated properly to do its job. I seem to remember that Walter S. at Sphere Research had a 7104 that was

Outstanding! I will definitely take a look! Thank you Roy and best regards! Jason

Hi everyone! I've had a 453A for a while now and recently a 150 Mhz 2445A (w/ Options 5 & 9) followed me home. Was hard to say no just for the measurement capabilities alone over my 453, I actually