开云体育

This sort of thing? https://www.die-wuestens.de/eindex.htm Craig

I've seen these XY oscilloscope clocks out there before and wanted to pick one up. Unfortunately, the Dutchtronix website shows "out of stock." Does anyone know if these kits are still being made,

Hello Tek fanatics! I have an MSO 3012 and I lent it to a friend. That was the last time it leaves the house! It came back with the message: something is wrong... Well you can say that again! I've

Thanks for the advice :-) Dave

Do you have the specific message from the error log? --Eric Sent from my Samsung Galaxy smartphone.

I got a good "new" Dallas DS1742W-150 from NAC in St. Petersburg, Florida. I had ordered some low profile pin carrier matching sockets, guaranteed to be here by today, but the Post Office lost track

I have the same problem too. Do you have any clue to solve this 320 error ? Thanks Simon

hi Bruce, I just acquired a Ballantine 6126M Oscilloscope Calibrator and its associated Time/Div. module in a browns Ballantine mainframe. My unit has some issues, and I would really appreciate

http://electroniccalibrators.tpub.com/TM-9-6695-274-14/TM-9-6695-274-140072.htm

Recent arrival: old Ballantine 6126M Oscilloscope Calibrator + a Ballantine Time/Div. module (model # ??), + a Tek DM 501 + an empty slot (?) in a brown (6-slot) Ballantine mainframe. a)

Older version of the PG 506 arrived with an ~ 1/2" dented-in front panel at the LED - Variable Amplitude knob juncture. Looks like it took a nose-dive to a concrete floor ! a) The

If you have to turn it CCW to see anything, but it is sweeping then the problem is obviously DC offset. First of all, how does it act in XY mode ? In the XY more if it is still offset to the right

Sounds like one side of the Horiz amp has a bad transistor.Is the horiz position knob skewed all the way to one side or the other ?If so, swap corresponding transistors until you see the trace skew to

Hello, Thanks Brad, Craig, Tim and Rogers for your heads up and sorry for the long delay in answering. Past was a busy and crazy week. In the end, I only wasted the bandwidth and your time because it

Don't forget Alan's freebie down in Brighton, if you fancy a repair: "I have a Tektronix Model 2215 to give away. It’s a 60MHz dual trace ‘scope, but it has a PSU fault, so it doesn’t power-up

I'm in Camberley, Surrey

Oddly enough storage was/is perfect on my 577. That isn't the problem. A couple of years ago I had a tant go short. To locate which board was the problem, I unplugged the power supply. Finding the

Hi Dave Approximately where in the UK are you, I may be able to help you. George ?G6HIG

Hi Wolfgang, Excellent! By the way, my storage 577 has similar "quirks" to yours. I tried adjusting it according to the manual and I found the directions very confusing. I finally gave up. Now I am

Thank you Dennis. I did accept that this fine instrument is working as specified. My last comment was regarding the storage option which I am not really worried about. I apologize if I gave you the