开云体育

Thanks Fabio for the reply. I opened my PDF copy of the 464 manual and found the +15 volt end of the wire on the TRIG-VIEW switch but didn't know where it went from there. Did some careful perusing of

For the purposes of harmonic generation NLTLs have much lower PN than SRDs. Bruce

Hello Jim, I used to owe a 464 that I refurbished completely, it had a DM44. I don't possess it anymore as I gave it as a gift to a friend... I disassembled the Vertical Pre-Amp board and the

Modern mixer diodes are great but I have yet to find a good replacement for step recovery diodes.

For people who like using linux and scripting and make files, (like chip designers), pcb-rnd is rapidly becoming a complete toolkit for making blind buried vias, defining groups of circuitry that move

If it works with the 7L12 but not with known good regular plug-ins. More than likely don't have the right buttons pushed ( or a bad button) . Take a deep breath and check that you have the trigger

Hello everyone, I recently acquired a 7603 with 7L12 SA. I got the pair to use the 7L12 with my 7904A but I really like the large screen of the 7603. So I'm planning to use the '03 for audio work. The

hi Ed, I believe that I had seen free .pdf manuals for the HP 70843b Error Performance Analyzer at the Kurt manuals site: https://doc.xdevs.com/doc/HP_Agilent_Keysight/index.htm However, a small quick

Gentlemen, Schematic/PCB software 5.0 from KiCAD, the massively powerful, long awaited, auto-routing and multi-OS integrated package, with better libraries and 3D models is now on their site for

Is there a complete inventory list?

Hi everyone, Ok, I've created a photo album ("DM5010 NiCad battery replacement info") with the battery schematic part and spec of the CMOS RAM. According to the DM5010 manual, the battery is to be

Where on planet earth are you? Craig

Hi, in my shed I have a lot of Tek bits including very hard-to-find long pots.have a few flybacks but not sure what state they are in. Anyone have a use and want to pay postage only? _A

I figured as much.? Thanks, Craig. Sent from my Verizon, Samsung Galaxy smartphone

It is possible when you use the rigid extender. The signal coax cables in the extender can be disconnected and in their place external coax cables to another scope's input can be connected, all BNC

As I remember it, NiCd cells can be left on trickle charge indefinitely, NiMh cells do require a lower trickle charge current. NiMh charging is intended to be C/4, C/2, or C (depending on the cell),

No, the idea is to plug it in, in place of either a vertical or horizontal plugin, and it provides standardized signals to the mainframe itself, allowing you to adjust two scopes to the same gain. It

On Sun, Jul 22, 2018 at 06:07 AM, Dave Hills wrote: > > Since this is a linear supply, not a switcher, I would not be concerned about > a 105C part, an 85C part should be just fine. I would first try

There are at least six groups that have to do with Tektronix test equipment: tekscopes.groups.io tekscopes2.groups.io tek500.groups.io (related to Tektronix TM-500/5000 equipment)

Since this is a linear supply, not a switcher, I would not be concerned about a 105C part, an 85C part should be just fine. I would first try to find a replacement with "snap-in" type leads that will