开云体育

On 2021-10-31 11:00 a.m., walter shawlee wrote: > Looking at the Tek curve tracer models and schematics, I see that the actual requirements for the tubes are very modest. No high frequency performance

These people may be able to supply something: https://www.accu.co.uk/en/p/27-custom-manufacture Geoff.

Looking at the Tek curve tracer models and schematics, I see that the actual requirements for the tubes are very modest. No high frequency performance is required, a flat face IS required, and HV

Bru, I have used for audio applications, Fader Lube from DeoxIT. https://caig.com/fader-f-series/ Dallas

I?ll do that later this evening. G?ran

Transformer data on KO4BB http://www.ko4bb.com/manuals/75.3.247.1/Tektronix_576_Tek_576_HV_Transformer_Winding_Data_Datasheet-Tektronix_576_HV_Transformer_Winding_Data.pdf

I dunno what a "lens" head is, nor whether you are looking in the UK or elsewhere, but have you tried: https://www.westfieldfasteners.co.uk They just might have something near. Colin.

I'm having trouble browsing the swedish version of the page, and the english just outright disables orders... would you mind checking if they have these screws?

Try this one: https://www.sifvert-skruv.com/ biggest store in Stockholm. G?ran

Hi all, I'm looking for metric M1.6 and M1.4 bolts in lengths above 20mm, with a cheese or lens head, and hopefully philips bitting. Located in the EU. Does anyone know where to get them? I've been

Dielectric greases are generally intended as insulators, so I would not go that direction. The silicone grease would probably be a good lubricant, but the conductive grease, probably carbon loaded,

Thanks for doing that and letting me know. I'll check there.

Years ago I scanned that manual and made the pdf available at Tekwiki. Albert

I was e-mailed the winding data of the HV transformer some years ago by a forum member since the 576 in my posession also had the leaky transformer. The winding data can be found in the manuals

This is always a popular and always an informative discussion when it comes up often, I don't know where all the responders are! A good question is what the difference is in the construction of the

Hi all, In addition to my previous request for TDS784C Firmware (5.x to 6.x firmware), I just acquired a TDS744A which is on early firmware too. So if anyone has a TDS744A or TDS784C and your unit

I have a PSA-225, fits 560 series scopes, but no manual. I emailed Brad and offered to buy his manual, but if someone else has a more direct need, I'll step aside or offer to copy this one. If anyone

I've just uploaded it to Tekwiki now. Regards, Jared

What are the odds that ebay external mixers are all bad and unrepairable? I guess what I'm asking is what the failure modes would be. Looking around a bit to figure if I want to jump up to microwaves.

I am cleaning up the Front Control PCB (A4 Front Panel Board) on a TAS465. TDS Series 310, 320, 340, 350, 382, 420, 430 use the same type of PCB Printed Control. I believe all of TEK Scopes during the