开云体育

Hey Carsten, does the Mastech MS8911 measure ESR? I can't find that function mentioned on their website.

At the risk of making it any busier in there, it may be one of my favorite places in the whole world. Despite being a complete greenhorn when it comes to most of the equipment, sneaking out of my

--- To rule out the simplest case, is "VAR" knob of sec/div switch in the calibrated position? Ozan

Roy, Just checked and it works perfectly. And so this will be my first and last ESR post on TekScopes. Thanks for the help! George KD6NEW

Easy enough to ask them if they are using an FDM ( fused deposition modeling) printer, an SLA (Stereolithography) Printer or an SLS (Selective Laser Sintering) printer. If they are using SLA or SLS,

I wondered if the finish might be superior to what some of the local shops might be providing. For the price difference, it's probably in my best interest to go with Shapeways. Thanks, Barry - N4BUQ

This is that odd L-shaped scope probe that is hard-wired into the little low frequency 211 mini-scopes. Hakan confirmed it fits the 211 for sure below B080000, and it may also work in the 212 and 214,

Sorry Roy, my topic is not spam. I am relatively new in these forums just trying to get my 2712 fixed. Have a good one Ronan

Hi Glydek: Apologies ... must have missed the notification. (Your in now.) PM if problems. Great! Look'n forward to your PCB! -- Roy Thistle

The SLS system produces better prints by far, SLS delivers near molded quality parts. -- Michael Lynch Dardanelle, AR

Those Surplus Sales prices are not practical for hobbyists, especially down here in Australia. I will post the schematic of my hack later today. It has the advantage of not requiring any alteration to

My 2465B has been sitting on the shelf for a few months. I notice when I fired it up today that the horizontal sweep is slow, by that I mean that the calibrator square wave does not line up with the

Note that Shapeways uses an SLS process which produces parts with great strength and very good dimensional accuracy. This may or may not matter for your part(s) but the quality and strength and

My fav: https://eds-inc.com/cap.html EDS 88A

Siggi, I connected via another authentication provider and submitted my design. Cost for plastic, including shipping and fees, was $0.70 more than what I was quoted by the local printing shop that I'd

Congratulations.? I'm looking for one, as well if anyone happens to come across one at a reasonable price point.? Sincerely, Christopher Juried Juried Engineering - Brand Name Electronic components

Roy, I applied for membership over a month ago and it has not been approved. If possible I would love to join. BTW, I rolled my own ESR as well.

For what it’s worth, I bought a P6601 temp probe…it wasn’t cheap, but I’m pleased with the purchase…$80 shipped for the probe brand new in sealed package with all original accessories and

Hi Ronan: Hi All: There is a groups.io group at: /g/ESR-Meters-North completely devoted to ESR/Capacitance meters. Dennis T. asked someone to create such a group... and to try and

Great suggestions all! Anyone used these from Bob Parker in Australia? https://www.evbesrmeter.pt/index.htm I do prefer the SMD tweezer type, I suppose I could make some various adapters/probes.