开云体育

I don't often post to this list but I do read and archive it. I just searched my archive. Jon Batters last posted to this list on 8/12/2018. There is no signature on that post, but previous posts from

Hi Rolynn, There are five Jon Batters listed as members. One is in the UK. I would guess that the other four entries are probably separate email entries setup by the same person for some reason of

I have a tm5000 setup (with appropriate plugins) sitting next to a 7904, which is next to an HP16702B, They all look good to me. On the other hand, I brought in a 7704 with a 7CT1N and other plugins

"Jeff Urban" <JURB6006@...> wrote: ========================================================== Jon Batters was a contributing member of this group. The information was for those who knew him and

First of all JEFF, both the sender AND the subject go back as far on tekscopes as most can remember and secondly………….WHY all the hostility!!! Can we not speak of humanity on tekscopes?

What in the hell does this have to do with Tektronix scopes ? In fact how did this get past first post approval ? Or does somebody have a trojan or something ?

Ok, the answer is (for those that don't know) that the J16 has two power module options: A mains power unit A battery pack with a separate charger. This is an either/or option where the chosen module

All kinds of folks selling NiMH charger boards for $10-$15 that are small enough to wedge in somewhere like this one 2"x2"x1"

I've heard several people say that NiCd cells tolerate a larger float current than NiMh. Since older equipment used NiCd, the float charge current (typically the way the cells were charged, say a 15

Hi Adrian, I was interested to see your suggestion of substituting NiMH sub-C cells for the original NiCds in the J16. Are you using the original battery charger? According to the J16 manual the

Eyebrows raised. I hope not, but if so I hope they find the perp and teach them a lesson. --Eric Sent from my Samsung Galaxy smartphone.

Group, The following was removed from my previous message. It is an email I just received from the Oregon State Police. Rolynn Tek Bvtn and Sunset 1966-1971

--- the forwarded message follows -- Is this the JON BATTERS of Grants Pass OR - a member of our group? Rolynn Tek Bvtn and Sunset 1966-1971

This 5B10N has a special blanking mode: https://www.ebay.com/itm/232916392120 Anybody know anything about it?

Hi Daniel, Quick response as it's getting a bit late this side of the pond but yes, the Tek J16 and it's range of sensors is pretty good and the instrument itself is nice and easy to fix too! I have a

Hi Folks, ? ?I just caught this thread because of the word "sensor" in the subject line - "photo-sensor" would have been more helpful, but I am glad I read the message, as it is a subject of

Thank you very much.?I was not sure if my TG501 is in the parameters, I did not have a 1GHz oscilloscope.? Now I can compare with the pictures posted.? Best wish. Petru

If keeping the existing photopic filter (I'm assuming there is one) then some research into the response of the current diode will be needed. I think an alternative might be to remove the current

And here's the album link for posterity: /g/TekScopes/album?id=69365.

As always, check the power supply voltages, and ripple first. Easy to do, the test points are right on to of the uncased instrument, and labeled too! Also, check the fuses under the little cover at