On May 2, 2023, at 3:46 PM, Lindley Ruddick <elruddick@...> wrote:

?Thanks for the information. I have never used any WOW sound decoders so I was unawsare of that.

Lindley

On May 2, 2023, at 12:37 PM, Tim Kelley <tim.kelley@...> wrote:

? ? ? ? ?scroll all the way down to the bottom.

Please note that a "normal reset" (by writing to CV8) is NOT a reset to factory defaults......

THAT is what the nuclear reset does....... which I cant get to work.

-=Tim

On Tuesday, May 2, 2023 at 02:32:23 PM CDT, Lindley Ruddick <elruddick@...> wrote:

I have been following this saga for quite some time but fail to understand what is going on.

What is a “nuclear reset”?

If it is a rest to factory defaults, why not just set CV8 to 2 or 8?

Am I missing something?

Inquiring minds want to know. ?:-)

Lindley

On May 2, 2023, at 11:38 AM, Tim Kelley <tim.kelley@...> wrote:

Good afternoon Dan, Andrew,
So I have removed JMRI / DecoderPro from our test case.
I am using a Digitrax DCS240+ command station, a SoundTraxx PTB-100 programming track booster, a Digitrax UR93, and a Digitrax DT602D duplex/wireless throttle.
I attempted to do a "nuclear" reset by programming the CV's directly by using the throttle.
I am using my dedicated programming track. I set the throttle to use Direct Mode on programming track (Digitrax documentation says this is the preferred mode)
CV201 = 5, CV202 = 0, CV203 = 0, CV204 = 8
I did the nuclear test sequence and nothing.....No Nuclear Reset..I read back the DCC address and it did not change.
I would have expected it to have gone to 3. (Correct???)
What are your thoughts? Any ideas?
Thanks,
Tim