¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Express Wind - Sunfish Clone


Wayne
 

Adi,

Take a look in the PHOTOS section at the "Other Fish" folder. Check
out the Barracuda photos. Does this look like your boat by any chance?


Wayne




--- In sunfish_sailor@..., "Aditya Garg" <gaajar@y...>
wrote:
Thanks Wayne,
This is certainly useful. I had come across something much more
abbreviated along similar lines. This should certainly help.

Adi

--- In sunfish_sailor@..., "Wayne Carney"
<wcarney@f...>
wrote:
Hi Adi,

I was able to pull up this record from the

U.S.Coast Guard Manufacturers Identification Code (MIC) Database

Hope it helps,

Wayne






MIC: GKD Status: Out of Business

Company: EXPRESS GLASS MFG

Company Official: GARRETSON, E. R.

Parent Company:

Parent MIC:

Address: PO BOX 463

City: BELHAVEN

State: NC Zip: 27810

Country: Phone: 9124376797

Fax:

In Business: 12/7/1980 12:00:00 AM

Out of Business: 2/22/1982 12:00:00 AM

Date Modified: 5/31/1990 12:00:00 AM

Type: Outboards, Open Motorboats, Jon Boats,
Sailboats, (with or without engine) Catamarans, Trimarans

Additional Address:

Comments: 2/84: PO BOX 1154, DARIEN, GA 31305

-7TH DISTRICT-OUT OF BUS








-----Original Message-----
From: Aditya Garg [mailto:gaajar@y...]
Sent: Wednesday, May 07, 2003 10:05 AM
To: sunfish_sailor@...
Subject: [sunfish_sailor] Re: Express Wind - Sunfish Clone


Oops,
A few corrections. Here is another attempt at the diagram.

<pre>

-------- ------------------
| | | || |
| | | -----|| |
| | | = | --- || |
| | | -----|| |
| | | || |
-------- ------------------
Sunfish Exp. Wind Storage

= is the self bailer

</pre>

There are actually a more differences from the Sunfish. The
deck
has
molded in non-slip surfaces. The splash rail is molded in and
is
much
closer to the mast step. 2 Hiking/toe straps are installed on
the
walls of the cockpit. The dagger board is GRP with a wooden
head.
There is no line attached to it. It stays up because of carpet
friction. The rudder appears to be different from the Sunfish
rudders.
It is also GRP. I'm not sure yet if it is a kick up rudder or
not.
Tiller is Aluminium. I am not familiar with the Sunfish bottom,
but
this boat is smooth kind of like a scow. The boat appears
heavier
than 150 lb. It might be because of water soaked up by the foam
blocks
in the hull. The bow is not pointed like the Sunfish, but is
almost
as
if someone chopped off the nose on the Sunfish and closed the
hole
flat. There are no cleats on the hull (which kind of concerns
me).
There is a drain plug in the transom.

Some of my terminology may not be accurate. I am a newbie and I
haven't yet sailed much.

Join [email protected] to automatically receive all group messages.