Hi Again .
I'm using the evoscan 3.0 to fine tune a rebuilt 1994 (OBD1) 2.2 legacy AT NA in my VW syncro. I finally got things hooked up and running . I captured some data . However .
Be aware . the software come with virtually no info and you have to join facebook to? ask questions . Understandably mot folks are not interested in OBD1 applications so im hoping someone here has some experience to share .?
2 things to know . Your purchase receipt has a code you need to activate the software and I had to get the USB driver from the TTL232 cable manufacturer here?https://ftdichip.com/drivers/d2xx-drivers/
I can see a fault code from the black blug diagnostics connector blinky lights on the dashboard (#24) but doesn't come up using the read DTC function in the software ... Q- do i need to connect the black read connectors to read the codes via the software ? will it work with power only or needs engine running.
Also there are 2 sets of 8 binary parameters Binary parameters that should be available :
-
Ignition switch
-
Automatic transmission mode
-
Test mode
-
Read memory mode
-
Neutral switch
-
Park switch
-
California mode
-
Idle switch
-
Air conditioning switch
-
Air conditioning relay active
-
Radiator fan relay active
-
Fuel pump relay active
-
Canister purge valve active
-
Pinging detected
-
Pressure exchange
Q- Is evoScan able to display these values ?
Dr Mark