开云体育

Cuts like that are for roughing materials for production work. If you're doing production work it's good to have that capability. Maybe even if you're not doing production work, if your shop time is

This only works if you sharpen your cutting tools according to the book using HSS.? That depth of cut is viable but the spindle RPM's are very slow and possibly the back gear is used. I have a HSS

I posted a video over in the Facebook thread that Eric has going on the same question. ?In the video I made yesterday, I turned .100” depth of cut, no issue. ?Have a

Many years ago in the files section of one of the many south bend related yahoo groups there was a drawing of a v-belt headstock pulley and discussion of groove angle etc. I though I had archived

A vbelt angle is about 34° a smaller size us different. If have under drive is vbelt only. If have a back motor drive you can use a ploy v belt that is a 40° angle. I did a ploy belt to a 9A about

Still restoring my UMD 9 inch which I am converting to a 10K. The back side of the door that accesses the belt change area has an instruction label. If anyone has one that the label is decent would

Is this the label you’re looking for? mine is a 10K but I suspect the adjustment (and label ) is the same. Not in perfect condition, but readable. mine has V- belt from motor to counter shaft and

Thank you. Sent from AT&T Yahoo Mail for iPad

Thank you Ray. I will print and save it. It’s better than mine as mine is gone!!Best regards, Larry Sent from AT&T Yahoo Mail for iPad

Hello all, new here so I'm hoping this is getting sent to the right place. I just picked up a 1947 C9-10JR.Most of it is there and looks pretty decent, after a quick clean it seems like everything

??? ??? The belt length is pretty dependent on the placement on the counter shaft . Page 5 of the attached manual shows dimensions of where South Bend decided the countershaft should be from the

Thank you, Mike Allen,? appreciate the download and the time to reply. I signed up to the site you mentioned and looked around, thank's, lots there. I found this on another site. It has the

Another consideration is whether you have a taper attachment or are considering obtaining a taper attachment. My motor/countershaft is too close to the bed and interfers with mounting the taper

Boltspinner Check out this Canadian group. https://canadianhobbymetalworkers.com One member has a surplus of SBs and has sold a few parts to group members. cheers John

can someone give the size of the Motor pulley the top pulley is a flat one I would like to find or machine a pulley for the motor shaft, thanks, Joe

Guys, I will ask again if anyone knows the size of the motor flat belt size or at least what size V pulley is used, thanks, Joe

Yer lookin for the pulley size for the " flat pulley on the counter shaft " or the 2 slot pulley on the motor ? I thought the 2 slot motor pulley was in the files section . animal

Are you talking about the belt from the motor to the countershaft or the belt from the countershaft to the spindle? If the countershaft assembly is mounted to the bench separately from the lathe,

I have a 5L width(21/32”) belt on my 1960s 9 inch. ?B width (5/8”) will work as well.

My measurements Motor pulley OD of flanges Small sheave 2.1” Large sheave 3.4” counter shaft large pulley 10” small pulley approximately 9” John