开云体育

The link is dead. Can you repost? Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Saturday, August 17, 2024 5:45:15 PM To: [email protected]

not mine but its a super low price https://www.facebook.com/commerce/listing/801555735520012/?ref=share_attachment

I agree!? But not so sure on practicality..... -- 1969 16" x 6' South Bend Lathe Garage full of old Mopars........

Hi There, I know I am late to the Party but I thought I would pass along a little knowledge about the Heavy Ten with the 1-7/8" x? 8tpi spindle. When the "Heavy Ten" first came out, it had that

This 10" chuck has been sold

drinkr55 Yes, your 50 hertz 1425 rpm motor will run at 1725-1750 on 60 hertz. I think your motor will have a centrifugal starter switch wired to the start capacitor. The problem with running 50 Hz

Update on 8-12-24: the 4 Jaw Chuck has been sold, but the 3 Jaw is still available.

only 5C collets were included

Any 6K collets there? Payson.

Thanks for the tip.? I checked with him today, but he didn't have either part.? - Stan

??? Ya may check with Ted , latheman for that broken collet rack bracket . Pretty sure he also has a steady for that lathe . ??? animal

Hi Mike, good suggestion, but I'm already set with chucks, I think. The 10L came with a Buck 3 jaw, and a 4 jaw.? And I've already got another 5.5" Bison 3 jaw that is in great shape.? I need to

I purchased a new SB 10L lathe yesterday...some history...I've had quite a bit of lathe turnover over the past 25-30 years: *1st:* Atlas-Craftsman 12" (~1997) - worked well.? Good starter lathe.?

WHy not just get/make? a couple of 2 1/4 backplates for them ? animal

In regards to your threading dial -- I made one from a 3d print pattern I found (on thingverse, I think. Mine was for a 10k, you'd want to check to get the correct version for your lathe). I had a

Update on 8-13-24: SOLD This was included in a recent lathe purchase, but is too large for my 10L.? It would probably be a good fit for a SB 13", which I think is also 2-1/4 x 8tpi. No marking

Two lathe chucks were included with my recent lathe purchase that don't actually fit my (1968) 10L. They are both 1-7/8 x 8tpi.? From my limited research, it appears that this is an uncommon size

https://www.youtube.com/watch?v=xXty__4Ogr4

Hi There, I can see that I am late to the party.? I have a wiring diagram for a Furnas drum switch that has the same jumper configuration.? I'll pass it along for your con- venience. Good

Thanks for all of your help I have the motor up and running as a result. I did notice that the 1425 rpm motor is running close to the 1725 rpm original. I’ll keep an eye out for any smoke or