开云体育

yeah i'll get back to u

Can you post a Pic or two? Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Saturday, February 10, 2024 12:40:07 PM To: [email protected]

i made a extention for the end of the spindle, at the same time i made it a nice spider for holding long stock. had to make a small alum bracket to mount the pickup on.

How did you install the sensor? I could not figure how to, from the instructions Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Saturday, February 10, 2024

i use a Tachulator.

hey folks have any of ya made a tachometer using a Arduino ? I tried some I found online but most of them seem to have something wrong with the code? I'm not smart enough in the Arduino world to

Nice non stock jackshaft, old .25 HP motor, tired belt, the ways look good, I have not run it, just picked it up and dragged it back. Remarkably clean, last used with wood. Harry wrote:

Nice tooling, what's the rest of the rig look like?

I have acquired a 9 Workshop surplus to my needs, Darien CT, any interest? Seems nicely kitted out, $1000? Harry

Was it a member here that bought one of the Rockettronics ELS ? thanks animal

That was pretty good........... -- 1969 16" x 6' South Bend Lathe Garage full of old Mopars........

https://www.practicalmachinist.com/forum/threads/south-bend-lathe-salesmans-car.148876/ some of ya may have seen this ??? animal

This guy deserves a drink , no several after all the work that went into being able to make this tube . There's a lot of info in this one https://www.youtube.com/watch?v=NcF3nVQnJzA animal

??? ??? I had a bud that had one of them 4wd ambulance's , bought it for 4 wheelin , by the time we got to the off road area we were too beat up from drivin in the ambulance for a hr? to go

If you've been to the WW 2 museum in New Orleans, you've seen the ambulance on the ground floor. It's outfitted with everything needed for combat. That truck, fully outfitted, would be a fantastic

I can think of several times in my past that havin that truck with the back equipped like the US ARMY? did would have helped me out of a jam on more than several occasions . animal

I've lurked on this board for years but never bothered posting.? Just to 'complete the loop' if you will, I'll add this to animal's post.? Will give some real pictures to the manual pages. I'm

Wow. What a fantastic piece of history that is. Best of all for me, and some of my friends is that I recognize, and use modern models of those benchtop drill presses. Payson