开云体育

I don’t know if the squeeze handle 10H is the same for the 10L . Dave

thanks , I have a squeeze hand that I bought , I needed the type that ya pull on the handle to move , I always get the 2 10" lathe mdl#'s mixed up . so if anyone needs a squeeze handle reverse

If you don't find someone else who needs them worse, I could use them if they'll fit a 1941 Heavy 10L.? Bill in OKC William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by:Good judgement comes

Squeeze handle. Dave

$1000.00 David Roenigk 9086 West Windsor Drive Olmsted Falls, Ohio 44138 I’m going to live forever…..So far so good firefite@...

Guys, I have some SB heavy 10 parts that I don't need. They weigh about 15 pounds, give or take a little. I can post a picture later today, when i get back from work. The price is $0.00 but you have

What are you asking for it?

??? does that have the squeeze lever reverse tumbler or the pull handle reverse tumbler ? thanks animal

I have a perfectly good 10H, well to get it out of the basement, I got a larger lathe, It’s no going in the basement. I had to take it all apart. I’m selling all Or parts of it. Dave I will ship

I was just coming around to that point of view. Thanks, Don

Thank you, Andrei. My sentiments, exactly! packard bill

Guys, just cut the damn belt. You can buy a new one for 40-50 bucks. There is no need to torture yourself and your machine for something that can be resolved with a swipe of a knife and, later, with

I just took a look at mine ( cabinet mount with the side panel removed at present) and it certainly looks like it should be possible in theory. I see direct access to the taper pin that secures the

Don Sounds like you got about as far, or maybe a bit further, than I did over 20 years ago before admitting defeat and cutting the belt. Burred over and damaged set-screw holes were definitely a

maybe... I think you may be able to do something if you don't try to take the belt off. If you can get enough belt slack to get the spindle out with out removing the belt you may be able to do

The belt, while running in forward, goes up the rear side of the spindle pulley,? down the front side of the pulley. If there there are separate passages through all that cast iron for the two

Ok everyone, now I could use some help. I determined that the right-side bearing is failing using a stethoscope. I need to talk with someone who has replaced the bearings on a Heavy 10 UMD Cone Pulley

A Guy on YouTube named WINKEY, is offering belting and glue, maybe he can offer advice and glue? ---- Flat Belt Fabricating and Splicing - Synthetic Belts

It’s a polymer belt, but that’s an interesting thought. I’ll check my notes. Probably been 20 years since I put it on ?. Don Sent: Tuesday, March 25, 2025 4:52 PM To:

If it was glued with hide glue can it be loosened with steam or water and then reglued later?