Re: Automotive flat belts for lathes
|
Nope. I have never done a YouTube video. AL-USA? (ww_big_al) ?
toggle quoted message
Show quoted text
From: [email protected] <[email protected]> On Behalf Of Mike Poore via groups.io
Sent: Sunday, December 29, 2024 7:29 PM
To: [email protected]
Subject: Re: [SouthBendLathe] Automotive flat belts for lathes? Are you "Winky?"
On 12/29/2024 3:08 PM, Mark via groups.io wrote: On Sun, Dec 29, 2024 at 12:53 PM, ww_big_al wrote: Winky’s work shop did a video on it. Using glue. ?
I need to do a new video on that. I sell a flat belt (Habasit F1). Anything under 2" wide for $5/ foot. I got a good deal on two surplus rolls. Most suppliers sell the same belt for over $13/foot. The recommended glue for this belt (and most) is Fixol but it requires heat. I also sell a belt guide and glue for $15 total but you have to buy a $20 heater. Basically, with shipping it will cost $45 plus the cost of the belt to be able to splice it on the lathe and about $20 plus the belt cost for me to pre-splice the belt.? - Thanks Al!
?
|
ww_big_al