A think a ?” minimum step overlap would be minimum
I’d try for 1” step, that should hold for years with the right glue, clamp, cure time.
toggle quoted message
Show quoted text
On Dec 28, 2024, at 7:45 PM, mikemm58 via <
mmcauley@...> wrote:
Thanks for the replys. I guess my main question would be the type of adhesive to use.??
Also, I'm not sure if i have the ability to cut an even taper on both ends, so I thought a stepped lap joint would work (??)??
(How much overlap should be good?)
The Duralast info states the material is rubber.
Mike
On Sat, Dec 28, 2024 at 5:33 PM, lance via?
I used one for years on my 16” SBL.
Cut on a taper. Use a belt sander to make opposing tapers on the belt
Glue, overlap the taper belt edges, clamp and let sit overnight.
I forget what glue I used, might have Been Permatex??
Lance
On Dec 28, 2024, at 7:12 PM, mikemm58 via
??<
mmcauley@...> wrote:
Hello,
?
Wondering if automotive flat belts (grooved serpentine type) can be put to use as a drive belt for my 10L.?
?
I just bought a Duralast #750K7 (7PK1905)
and before I cut it and try to glue together, has anyone had prior success?
?
Thanks...!
?
Mike
