|
toggle quoted message
Show quoted text
From: [email protected] <[email protected]> on behalf of houdini via groups.io <houdini969@...>
Sent: Saturday, February 10, 2024 2:26:39 PM To: [email protected] <[email protected]> Subject: Re: [SouthBendLathe] Arduino tach ?
On Saturday, February 10, 2024 at 01:06:02 PM EST, Andrei <calciu1@...> wrote:
Thanks
Get
From: [email protected] <[email protected]> on behalf of houdini via groups.io <houdini969@...>
Sent: Saturday, February 10, 2024 12:50:57 PM To: [email protected] <[email protected]> Subject: Re: [SouthBendLathe] Arduino tach ?
yeah i'll get back to u
On Saturday, February 10, 2024 at 12:44:41 PM EST, Andrei <calciu1@...> wrote:
Can you post a Pic or two?
Get
From: [email protected] <[email protected]> on behalf of houdini via groups.io <houdini969@...>
Sent: Saturday, February 10, 2024 12:40:07 PM To: [email protected] <[email protected]> Subject: Re: [SouthBendLathe] Arduino tach ?
i made a extention for the end of the spindle, at the same time i made it a nice spider for holding long stock. had to make a small alum bracket to mount the pickup on.
On Saturday, February 10, 2024 at 10:14:18 AM EST, Andrei <calciu1@...> wrote:
How did you install the sensor? I could not figure how to, from the instructions?
Get
From: [email protected] <[email protected]> on behalf of houdini via groups.io <houdini969@...>
Sent: Saturday, February 10, 2024 9:30:10 AM To: [email protected] <[email protected]> Subject: Re: [SouthBendLathe] Arduino tach ?
i use a Tachulator.
On Friday, February 9, 2024 at 02:56:47 PM EST, mike allen <animal@...> wrote:
hey folks have any of ya made a tachometer using a Arduino ? I tried
some I found online but most of them seem to have something wrong with
the code? I'm not smart enough in the Arduino world to decipher the code
. What are you folks using ? I don't want to buy just a tach from China
. I need to get one working in the Arduino platform for part of a
project I've got going . thanks
animal
|
