As "generous" as your offer is, I could not do that to you. Sadly, I
think I have used it once in 3 years.
On 12/27/2023 10:26 PM, mike allen
wrote:
toggle quoted message
Show quoted text
??? ??? Ya could just remove the taper attachment & send it
to me , I'd take one for the team . I think they had covers like
yer askin about for the Craftsman lathes . I think there's a few
folks here with Craftsmans , maybe they could chime in on that .
animal
On 12/27/23 6:45 PM, Mike Poore
wrote:
I have a SB9A with taper attachment. I would like to fashion a
cover for the cross slide and taper attachment as it seems like
the most time consuming area to clean. There does not seem to be
an obvious way to attach covers without some hole drilling,
which I prefer as a last resort. The cross slide screw is most
annoying to clean, but the taper attachment as a whole is a
pain. Removing it when not using the taper attachment is the
obvious solution, but I would like to avoid that as well.
Does anyone have photos of how they deal with chip control?
