??? ??? Ya could just remove the taper attachment & send it
to me , I'd take one for the team . I think they had covers like
yer askin about for the Craftsman lathes . I think there's a few
folks here with Craftsmans , maybe they could chime in on that .
animal
On 12/27/23 6:45 PM, Mike Poore wrote:
toggle quoted message
Show quoted text
I have a SB9A with taper attachment. I would like to fashion a
cover for the cross slide and taper attachment as it seems like
the most time consuming area to clean. There does not seem to be
an obvious way to attach covers without some hole drilling, which
I prefer as a last resort. The cross slide screw is most annoying
to clean, but the taper attachment as a whole is a pain. Removing
it when not using the taper attachment is the obvious solution,
but I would like to avoid that as well.
Does anyone have photos of how they deal with chip control?
