开云体育

I was thinkin bout the left end of the spindle also , but then would I have to move the magnet if I wanted to put a spyder on ? Don't know . As usual I have been over thinkin this for a while .?

I just finally got my lathe moved over to the new place on Saturday .I have crashed cars,trucks,motorcycles , rolled a water truck & I don't think I have ever had the pucker factor as high as when I turned down my dirt road with the lathe on a trailer? . Amazingly all the loose hardware I left on the bench is right where I left it . Now I have to get one of my roll-aways moved with all my machine tools . We finally got moisture on the ground , so I gots mud everywhere .

thanks

animal

The ones I have seen have the sensor on the backend of the spindle

Get

---

From: [email protected] <[email protected]> on behalf of mike allen <animal@...>
Sent: Wednesday, December 20, 2023 6:00:39 PM
To: [email protected] <[email protected]>
Subject: [SouthBendLathe] Tach pickup Location

?

Hey folks , I know some of ya have put Tach's on their 9" lathes . Where
did ya put the pickup ?? I'm doin a project/experiment & I will be
needin to put a Tach pickup on my 9A spindle . Rite now I'm leaning?
towards a magnetic pickup cause of the size of the sending unit & magnet .

thanks

animal