I was thinkin bout the left end of the spindle also , but then
would I have to move the magnet if I wanted to put a spyder on ?
Don't know . As usual I have been over thinkin this for a while .?
I just finally got my lathe moved over to the new place on
Saturday .I have crashed cars,trucks,motorcycles , rolled a water
truck & I don't think I have ever had the pucker factor as
high as when I turned down my dirt road with the lathe on a
trailer? . Amazingly all the loose hardware I left on the bench is
right where I left it . Now I have to get one of my roll-aways
moved with all my machine tools . We finally got moisture on the
ground , so I gots mud everywhere .
thanks
animal
On 12/20/23 4:27 PM, Andrei wrote:
toggle quoted message
Show quoted text
The ones I have seen have the sensor on the
backend of the spindle
Get
Hey folks , I know some of ya have
put Tach's on their 9" lathes . Where
did ya put the pickup ?? I'm doin a project/experiment
& I will be
needin to put a Tach pickup on my 9A spindle . Rite now
I'm leaning?
towards a magnetic pickup cause of the size of the sending
unit & magnet .
thanks
animal
