On Jun 24, 2023, at 8:20 PM, Steven Schlegel <sc.schlegel@...> wrote:

?I have a simple question. How deep of cuts do you normally make?

I have a 1949 vintage SB9C, with 6 speeds. I replaced the 1/4 hp motor with a 1/2 HP one. I use carbide a lot, but HSS still gets used some. Many of the videos say I should take at least a 0.005" cut for the best finish. I usually cannot take more than 0.002" with dragging down, or stopping, the spindle.

What's reasonable for me?
Thanks, Steven