¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. SouthBendLathe
  2. Messages
Single Messages Topics Expanded Polls

Re: ER Collet nut

 

But it does work as that is how I have been threading Metric since making the 4 stud gears I needed. Its important to note that when reaching the end of the thread on each pass you STOP the lathe, then dissengage the half nutsand return to the beginning of the next cut, now note; ?just return the carriage slowly untill you can re-engage the half nuts to the marked position from your first cut. And then repeat this procedure untill completing to your desired fit.
?I must impress though, that you should select a spindle speed that allows the spindle to stop fairly quickly or. having a VFD with breaking set light(as I have) allows a fairly quick stop without threat of losing the chuck ;) BTW I have 1947 9A and a 1986 10K underdrive - with a Hitachi VFD

On Wednesday, February 15, 2023 at 09:18:51 AM PST, m. allan noah <kitno455@...> wrote:


Too bad it isn't true.

allan

On Wed, Feb 15, 2023 at 11:53 AM Andrei <calciu1@...> wrote:
Yes, that is the plan, anyway. ?
From: [email protected] <[email protected]> on behalf of Rick <vwrick@...>
Sent: Wednesday, February 15, 2023 11:49 AM
To: [email protected] <[email protected]>
Subject: Re: [SouthBendLathe] ER Collet nut
?

Are you saying you can just disengage the half nut, hand crank the carriage back, and restart on the same number?



On Wed, Feb 15, 2023 at 10:58 AM, Andrei wrote:

The only difference between metric and imperial on using threading dial is that with metric you have to start ON THE SAME mark, every time.?
?
From: [email protected] <[email protected]> on behalf of William Nelson <wnnelson@...>
Sent: Wednesday, February 15, 2023 10:55 AM
To: [email protected] <[email protected]>
Subject: Re: [SouthBendLathe] ER Collet nut
?
I had that idea a while ago as I had some parts to make that would have been easier to leave in the chuck and go back and forth to the lathe and mill. I considered using carbide tooling to thread a commercial hex block as there was sufficient wall thickness for the threads. I never got around to it but it is still in the back of my mind. If I had a surface grinder making one would be much easier. I have a 10k and have used the printed gears from Ebay with great success making metric threads. I believe I saw a way to use the threading dial on you tube but never tried it. Something about using the same mark on the dial I believe but don't hold me to it.
--
Bill From Socal



--
"well, I stand up next to a mountain- and I chop it down with the edge of my hand"
Join [email protected] to automatically receive all group messages.