开云体育

We got lucky, the velcro we ran into is old stuff and we’re able to peel away without too much difficulty. Leaving in the morning. Dave Second Star S362 #113 Fair Haven, NY/Lake Ontario

John one more thing. Mars Metals I believe built our Sabre keels. Give them a call too. Here’s a link to their website. https://marsmetal.com/ Len Bertaux

While I’m not personally familiar with yards in NY and CT others on this list are, I’m sure. Carter would you like to chime in? I’m not sure why you think the bolts need replacing but the

Thanks Jim, we have decided to change to the Isotemp 20 l (5.3 gal) heater for the replacement. It is about half the price of the Raritan and includes a drain and tempering valve. It has a stainless

Ossining ny [email protected]> wrote:

Lots of yards. Where’s your boat? Len Bertaux

A pair of well known Sabre sailors from the Chesapeake did the same stop, then returned to Vero permanently. It’s a nice place, especially now, but you have to have your eyes open about Florida

Who in the Northeast is qualified to replace the keel bolts if I remove and replace the keel myself and transport it to the recommended facility? Thanks John Sheehan Sabre

He is still working and not retiring yet. I just spoke with him yesterday. Allison Lehman Swiftsure Yachts allison@... Cell: 510.912.5800 Fax: 510.860.4640 ?

Defender purged the old database a while back. Dave

Hi Jim, Yes the original Raritan 12 gallon unit. When winterizing, I pull both cold and hot hoses off and join them together. Then I have to disassemble the bottom piping because that check valve down

I bought six, for my 362, in 2021 from Fisheries Supply

Dan I got the part number from Defender. Jim Kerney had purchased them, and I had to call up Defender and have them go through HIS orders to find the number. I doubt I could do that trick with the new

I had an email exchange with Glenn last week Mitchell Sogin IPhone 5085661468

The last word on that ~6 months ago were that reports of his retirement had been greatly exaggerated. Perhaps something has happened since but? . . . . . .

I believe some reported that Glenn Chaplin had retired. Does anyone have the current Sabre contact's email address?? I tried to make an enquiry using the online contact form, but don't think it was

Thanks Jim!? I didn't know that OEM replacements were available, since Lewmar's website is hopeless and Defender is not quite as bad. Ronstan also makes a ball bearing block that looks like it will

-- Jim Gregory Sabre 402 #32 Milford CT https://defender.com/en_us/lewmar-organizer-delrin-repl-sheave-15900496g?srsltid=AfmBOop1uobpmbz_0grjThz5xSfZDKkfa54k3Q5t2wRzw4oWcgxH1Mz1

Here they are. https://defender.com/en_us/lewmar-organizer-delrin-repl-sheave-15900496g?srsltid=AfmBOop1uobpmbz_0grjThz5xSfZDKkfa54k3Q5t2wRzw4oWcgxH1Mz1 -- Jim Gregory Sabre 402 #32 Milford CT

I had to replace some sheaves on my orginisers and found the part numbers. I believe i ordered them from defender. I will try to dig up that info. Pretty sure I posted here about it. Hmm -- Jim