开云体育

Since the question of tonnage originated from a Canadian sailor, this might be necessary to keep in mind... The measurement system used for GRT and NRT can differ depending on the country and its

I have a used functional Sea Frost ED System. It was fully functional when removed last August. It was removed because the copper lines were beginning to corrode and had begun leaking. To install it

Scott: The shower sump drain on my 402 is drained by a shower sump pump; which pumps ?it to the sink drain. Andy Snowy Owl 402 #40

One last point - the base of the shower is below the water line, thus, a pump is needed. Fair winds, Mike ~~ _/) ~~

In Sapphire, our shower drains via a pump, which is actuated with a switch in the shower area. The forward drain, in the head section, drains as you described - via water heater area to the dripless

After 31 years the Attwood bilge pump in the Attwood shower sump gave up the ghost. Not a problem except Attwood no longer makes a drop in bilge pump that fits. To top it off, they no longer make the

On our 402 the shower drain goes to a strainer with a screen in it then to a pump and into the head sink drain. The pump switch is next to the door for the wet locker in the shower and the strainer

Hello Scott, On my 402, both of those drains are connected via discharge hose to a pump that draws the water up and into the discharge hose into which the head sink drains (and ultimately to the

We usually stop in Cuttyhunk at least a few days a year. We are booked in Edgartown by the ridgid dockwa app so dont know when we will hit Cuttyhunk. -- Jim Gregory Sabre 402 #32 Milford CT

According to my registration the 425 gross tonnage is 18 GRT. ?Net tonnage is 16 NRT. Kevin McMahan Nocona Moon Sabre 425 #1 HWS 42063A090

Same on 362. Drain to bilge bad idea. Real bad.

On hull 32 the shower drain goes through a filter then to a pump then out the sink drain. The pump is fused at the main panel and has a switch in the shower. I have no idea where the head compartment

Hey all. ?New 402 owner here... ?Today, I noticed when water drains from the head or shower floor drain, the water enters the bilge area under the water heater. ?If there is enough water, it

You may be able to get the dimensions you need from this scaled drawing. Jeff Boyle Daystar S425 #79 Chicago, IL

2019, insurers abruptly stopped insuring USA boats, two weeks before our UK policy expired. The solution was a suprisingly easy switch to UK ship registry. It was cheap to do so, the only real expense

Hello Bil, As noted, I did not have to remove the shaft. ?Once the coupling is removed and the PSS Shaft Seal components are removed, the shaft can slide as far back as far as the rudder, giving you

The yard did mine in 2021 - /PSS ( Packless Sealing System ) - 1-1/8" Shaft - 2-1/4" Stern Tube/ Installed a new Sigma Drive coupling at the same time.? I don't believe they pulled the shaft all the

Just remember that if it makes sense to you, you don't understand it. -- Jim Starkey, AmorphousDB, LLC

Check the measurement. The Gross Tonnage is a measure of the boat’s volume. If the boat has an encapsulated keel, then the boat’s draft is used in the calculation, because the ballast is inside

Hi all, I plan to replace my PSS shaft seal in coming weeks. I'm away from the boat right now and need help with some items. Can other owners confirm that the PSS Pro 03-118-214 seal is correct for