开云体育

Bill - Have you removed an engine mount to see if the mounting holes are original or if there are more than 2 holes per engine mount? ?The reason I ask is everything I am seeing shows the 35D having

I have a Westerbeke W21 that I have tore down and have many parts for it. I was told the motor ran before I bought it but the exterior was in fair to poor shape. I am only keeping the parts I know are

Thanks everyone for chiming in. Measurements on the boat today show the deck cutout is 20.375" square, outer dimension of hatch flange is 22.5" square, and height is 2" all of which are pretty close

Is it to stop drips from going in? Allison Lehman Swiftsure Yachts 510 912-5800 cell 510 860-4640 fax allisonleh@...

Yes, drip edge... I couldn't think of the name of it. Thanks for the info. -- Robert s/v Valinor Sabre 34 Mark I #207 New Bern, NC

More like a drip edge. Any water will get to the edge and drip off outside. If that wasn’t there, water could run along the wood and drip on the inside. Dave Second Star S362 #113 Fair Haven,

Is this groove for something like a door sweep? See pic and thanks. -- Robert s/v Valinor Sabre 34 Mark I #207 New Bern, NC

Our 1995 362 #150 has Lewmar Size 60 Ocean Series Hatch. We replaced both in 2021. I think we got them from Defender, but I’d have to check receipts since as everyone knows Defender purged their

And they are flanged. I just happened to be sitting beneath one and it is 20”x20” on the inside of the flange. Hatchmasters.com is a good source for parts, repairs, and new lenses. Dave Second

I can't remember what size they are but they are the Ocean Series Allison Lehman Swiftsure Yachts allison@... Cell: 510.912.5800 Fax: 510.860.4640 ?

Attached is the Ocean Series spares manual.? I believe on my 97 362 the two mains are size 60 but I am 350 miles away from the boat and can't find notes on them.

All, which Lewmar model are the 2 main hatches on a 2003 362? Anyone know if they use the flange or flat base? Thanks, Bill Graves 2003 S362 #261 'Souwester' Marblehead, MA

Hi all, I plan to replace my engine mounts since at least 1 appears broken (lots of rubber dust around it). Can anyone recommend which model should be used for a Westerbeke 35D? Current mounts have

No, no, he’s correct. It is necessary to have a high voltage and current applied to the keel and fresh epoxy that helps fuse the epoxy to the lead. Is it April yet? Dave Second Star S362 #113 Fair

“Light sanding”. I think lightening is a bit drastic.

Roger strip keel to bare lead. Clean metal with a wire brush on a drill or grinder. ?Get any oxidation off. Immediately roll on epoxy resin with no filler. Wire brush the keel and resin. Let it cure

Straight epoxy, with no filler? From: [email protected] <[email protected]> on behalf of Allison Lehman via groups.io <allisonleh@...> Date: Sunday, March 23, 2025 at 12:30 PM

You must epoxy first.

When I hauled in 2015 in Mexico, the bottom paint and epoxy wre flaking in a few places so we decided to do the “patch” process instead of a full strip and re-epoxying. What we found were voids in

How do you get anything to stick to lead? I did some fairing and it peeled off the same year. Roger Kuebel Restless S362#150 Padanaram, MA From: [email protected] <[email protected]> on