开云体育

Tim, this kind of damage would not br obvious without dropping the keel, am I correct? Mike s/v Ladylike 88 38' MK II [email protected]> wrote:

Hi Manny, In many cases, it is very obvious. If you have serious corrosion present - a visual inspection will clearly identify any severe bolt/nut corrosion issues. If a keel has mysterious leaking

Thanks! I'll keep that option in my back pocket. I had thought that I could substitute a 1-1/2" sheave from Schaefer or Ronstan, but from the photos, the organizer appears to have bushings between the

I was pretty sure that was the case, at least for Hull #70, but planned to inspect just because there was a question.? Glad to check that item off the list.

Cool. Impacts resale. Tony Tony Billera tony.billera@... 206 605 2650 linkedin.com/in/tonybillera Please consider the environment before printing this email. Thank you.

I may misunderstand. The description sounded like it tied into the thru hull. Would need a loop to prevent leaking backing into bilge wouldn’t it ? Tony Tony Billera tony.billera@... 206 605

5.3 is enough for two people that are cruising. It's always good to be conservative with fresh water use on a boat. I got by nicely with heaters of that capacity for years. My 12 gallon tank is an

Hi All, How have you determine when it is time to replace the keel bolts? Thanks, Manny Moreno SV Blue Wren - 34MkII

Tony, I’m not sure I understand your question. If the shower drain were to leak, it would go to the bilge and be limited to how long the shower is running… is that what you mean?

Thanks Jordan I'll pass my frame is good? Mike

? So a leak in the shower drain can sink the boat ? Tony Tony Billera tony.billera@... 206 605 2650 linkedin.com/in/tonybillera Please consider the environment before printing this email. Thank

I did some digging into this and hopefully have some closure for the topic. Hull #004 and #047 both T into a smaller hose that goes into the pump and then overboard via the sink thru hull. The

Mike, the Bimini is blue. But I would say that the value is really in the framework, and since the fabric was made for the framework, it likely would only work with the framework. let me know if

Hi Allison, MARS is an hour from me so its the best alternative that I have at the moment. I am not replacing the keel, just the bolts.? I will ship the keel to them and they will replace them by

Terry, If you have 20 feet, you have plenty of room. Maximum road height clearance is 17.9" and I had the boat transported from MD. I had measured it prior and it was under 12'. Tim R 38MKII in refit

Terry measure the binnacle and wheel as well. That is usually the highest spot and what we take down for shipping. With 20” you should be fine. You might want to check with Glen and ask if he has

Thanks Tim, I think the stantions might be the highest point. I would rather not have to remove them. The barn door height is 20ft. My gut feel is that we should have plenty of room even with the

Hi Dan I replaced all the sheaves in my deck organizers ?a few years ago with sheaves from Zephyrwerks, they are far superior but expensive. Google them and you’ll find their website. Allan Dagny

Thank you all very much.? Gus

5.3 gal ? That doesn’t seem to be much hot water. Ours is 12 gal on the Delphia 40. Tony Tony Billera tony.billera@... 206 605 2650 linkedin.com/in/tonybillera Please consider the environment