开云体育

Hi Mike, According to the hamVOIP website, there should be no issue as far as the software. But we need to consider a potential hardware issue.? The Pi3 and Pi4 are rated to supply 1.2 amps +/- 10%?

I'm looking to purchase two SHARI's, namely one 2m and one 70cm. Is there any issue with running two on a single Pi? Reason being there are times when I will have a 2 meter only radio, so I kind of

The frequency has to be entered as 439.0500.? Four numbers after the decimal point. *Enter Tx Frequency (xxx.xxxx):*

I am getting the following error when I run this. Sending Freq Information... ??? Error, invalid information (+DMOSETGROUP:1). Check input format.. ?Command Sent: ???????

There is a discussion on the HamVOIP ARM-allstar list about how to remove the 'squelch crash' when using SHARI.? This is typically done using CTCSS with reverse burst.? For this to work, the radio

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the [email protected] group. * /shari-pixx-prog (

Hello, I received the 2 meter and 70cm shari kits this week. I put the 2 meter and 70cm antennas on my MFJ antenna analyzer. The 2 meter antenna has a high SWR 10:1 at 146.52 on the 2 meter ham band.

Steve, I have run the DRA818's as low as 3.0V but have not gone the other way..They run fine at 3.0...Or at least the one I did run there did.

Hi Lawrence, Thanks for the suggestion.? I have not investigated the Dorji DRA818 transceiver modules because the specified input voltage is 3.3 - 4.5 volts while the NiceRF SA818 is rated for

I have used the DORJI DRA818(V/U) series of Transceiver chips. I believe they are pin for pin compatible to the SA818. Because the DORJI are wide-band only, they would lend themselves to Amateur

The current batch of SA818 VHF and UHF modules that we acquired arrived with the Channel Selection feature enabled.? The previous batch were programmed to wideband and ignored this setting.? All

Why the change for channel setting to 1? In a previous message on this group you mentioned that it did not matter if it was set to a one or zero. You said that the SA-818 devices you were using were

Hello, This email message is a notification to let you know that the following files have been updated in the Files area of the [email protected] group. * /SHARI Allstar Node Setup Procedure-Version

Just take the default by pressing enter.

Hey guys, OK, 1 more question, the last few questions in the 818-prog it asks about the foltering, and pre-emphasis and all that. What should i set them to? Cheers, Jed

Hi Jed, Set the volume to 8 when programming SHARI. Steve - N8AR

TX or RX? So far, I have a G7RPG node running Hamvoip, but I'm running TX volume at 600 and RX at 999.

Hey guys, So i'm going through the 8181-prog. I got everything, but it asked for a volume level, what should i set that as? Thanks, Jed

Hey Steve, Thank you so much, this is exactly what i was looking for. Awesome. Cheers, Jed

Hi Jed, Below is a list of Numerical Numbers, PL codes and PL Frequency.? You enable the desired PL frequency by entering the numerical number as a four digit number (i.e. enter leading zeros) when